Apple MacBook Pro 13" A2289 820-01987 Schematic & Board View
820-01987
820-01987
-
Hello,
This special tool from Apple is used to recover data from Macbook A1706. I've been using it for a while but it stops working. When connecting Thunderbolt 3 between the tool and working Macbook, Macbook should prompt "new device detected, allow or not"... but it doesn't.
Has anyone ever experience this ? It's not a cabling or power supply issue, some IC have stopped working but not sure which one. Probably the one that manager thunderbolt 3
Thanks
Claude... -
Hi everyone - first time poster on here looking to embark on my first repair! Thank you in advance for any help!
My Macbook only turns on when the charger is plugged in and only the trackpad and fans show signs of life. The display, caps lock light and touchbar do not turn on. There was previous liquid damage to the touchbar but after cleaning and drying the laptop was operational for a year without any issues. There doesn't seem to be any sign of liquid damage to the board, at present.
What I have done so far:
- All of the routine diagnostic methods including... -
I got this Apple MacBook Pro A2289 EMC 3456, it was working 100% fine. I started it's updates. I am assuming that, it was writting to the SPI Bios. There after the updates, it re-booted & then no display at all. Am I doing something wrong? Are there any Bin files for this notebook & is it written the same way as older MacBooks? The amp meter shows that it taking it's 20v but amp is aorunf 0.40 ~ 0.70. If some can help & give me some information, I would be grateful. Thanks in advance. -
Hello Gentlemen,
I am working on an apple MacBook A2442 board pn 820-02098-A with a visible short on the PMIC U7700 MVK-PLUS as per the schematics
I have a donner board from apple macbook pro m1 A2338 PN 820-02020 and I saw that the PMIC U8100 TMLT46B0-JPE could be a possible replacement for the U7700
Can you please help me confirm if the U7700 can be replaced with U8100 ?
APL1098 is it the same as APL1096
Thank you very much in advanced
Ahmad -
Hi there,
I'm looking for anyone who might have information on Apple's embedded Apple Watch charging daughterboard, ID 820-02601. This is currently used by Anker in their Apple Watch charging products, but likely by other Apple partner brands as well.
You can see the board referenced in ChargerLab's teardown of the Anker Y1811 3-in-1 MagSafe cube - they discuss the "Apple Watch wireless charging circuit" about 2/3rds down the page. It's not pictured, but the board ID reads 820-02601-A, which sure sounds like Apple.
This daughterboard uses an interesting...04-21-2025, 11:41 PM