Asus f15 Fa506 no screen BQ24780s

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • greg1985
    Member
    • Oct 2023
    • 13
    • Polska

    #1

    Asus f15 Fa506 no screen BQ24780s

    Hi to All. Problem with laptop is no screen after power up. I have changes bios software many times and there is new bios chip also. Laptop still coming on with no picture.
    Every power line is present.
    I have noticed that in off Mode laptop take 7mA and then 10 to 16mA and coming back. Was interesting what is taking this current. Bq24780 is flickering. I check there is 2.6v, 6v, 18v present. Baterry is charging. What could be problem then? When i remove bios chip laptop takes 7mA only. Could be bios issue still or next step is kbc?
  • greg1985
    Member
    • Oct 2023
    • 13
    • Polska

    #2
    This is third BQ ic tested and still the same

    Comment

    • mon2
      Badcaps Legend
      • Dec 2019
      • 13830
      • Canada

      #3
      Bq24780 is flickering.
      Can you clarify this comment? Which exact battery charger IC was onboard the original logic board?

      Comment

      • greg1985
        Member
        • Oct 2023
        • 13
        • Polska

        #4
        When laptop is connect to power, under thermal camera bq ic get hot, pulsuating. power supply shows 7 to 16mA. Also I've noticed strange voltage on BATFET gate - from 6.5 to 8volts and changing. There should be voltage from BQ ic connected by 4kohm resistor. But i dont know why this gate voltage changing.

        Comment

        • greg1985
          Member
          • Oct 2023
          • 13
          • Polska

          #5
          Orginal is Bq24780s.

          Comment

          • mon2
            Badcaps Legend
            • Dec 2019
            • 13830
            • Canada

            #6
            Part should not be heating up.

            1) Soldered in properly? Pin #1 to pin #1 on PCB? No solder shorts?
            2) Some offending interconnect is causing this fault. Flux and remove the batfet to test if the issue is resolved. Perhaps leaking?

            Comment

            • greg1985
              Member
              • Oct 2023
              • 13
              • Polska

              #7
              Thank You for response. Yes i will do that. My next idea is also to take another laptop (diffrent company) but with the same BQ ic and check pin voltages also.

              Comment

              • mcplslg123
                Badcaps Legend
                • Jun 2015
                • 7262
                • india

                #8
                If battery is charging fine,BQ24780S is unlikely to be faulty.

                Check powergood signals one by one.

                Mention the voltages on all coils after powering on.

                All_SYS_PWR_Good is present?

                Comment

                • greg1985
                  Member
                  • Oct 2023
                  • 13
                  • Polska

                  #9
                  Thank You for reply. Update is: oscillating voltages on bq ic could be normal. Found on other forum voltages but not sure for 100%.

                  Comment

                  • Sametbey
                    Badcaps Veteran
                    • Jan 2021
                    • 229
                    • Turkey

                    #10
                    It was taken from a working device, it may help.
                    Attached Files
                    I'm not happy to be so strong. because it's not humanly

                    Comment

                    • greg1985
                      Member
                      • Oct 2023
                      • 13
                      • Polska

                      #11
                      Thank You.

                      Comment

                      • greg1985
                        Member
                        • Oct 2023
                        • 13
                        • Polska

                        #12
                        Update. Found missing resistor line 1.8v_gpu_aon.
                        Closed. Thanks for help.

                        Comment

                        Related Topics

                        Collapse

                        • razor_amd
                          [TUTORIAL] fix asus bios with bios from asus web support (by razor_amd)
                          by razor_amd
                          With ASUS, not everything is quite so simple. I will show you my way. It may be longer or harder but it is the right way to do it in my humble opinion.

                          For example, you can have 3 similar ASUS motherboards, all being the same model, all of which will have different BIOS versions.

                          I will give you an example and my version of preparing BIOS from ASUS website and in the process I am always cleaning Intel ME while doing it so you have fully cleaned BIOS, no DMI data, no password, nothing.

                          This is the picture of 3 similar ASUS motherboards, all of them being X555LD...
                          12-15-2020, 07:07 PM
                        • throwaway327
                          Asus ROG Ally X -RC72LA - changed hidden bios settings with 'Smokeless-UMAF', won't get past boot logo
                          by throwaway327
                          ASUS ROG Ally X - (Handheld Gaming PC)
                          Model No: RC72LA
                          Serial No: SBNVKD001014459

                          Hi all, I've spent the past week digging through the forums and guides to try correct my foolish mistake of changing hidden settings while tinkering around, and to be honest my heads overloaded so I'm hoping you'll be able to help.

                          I used a tool called 'Smokeless-UMAF' to access usually hidden settings in the bios. I tweaked one or two 'safe' things but made the mistake of tweaking a lot of settings under 'USB/Thunderbolt Configurations' when I didn't know what they did. For...
                          06-18-2025, 05:52 PM
                        • Technodoc
                          ASUS G614JZ-N3012W Rog Strix need some bios help, laptop black screen
                          by Technodoc
                          Asus laptop G614JZ-N3012W Rog Strix with i7

                          Mainboard G634J-PMV-VGT
                          6050A3441302-MB-A01
                          2023-02-10

                          Power button works okay....power light goes on
                          Red "bottom" leds go on
                          Charging led works

                          Fans do not spin, capslock key does nothing, screen stays black

                          I would like to program the bios again, to rule out a corrupted bios.
                          However I run into a size error

                          The bios chip is a Winbond 25R256JVEN
                          Used my Xgecu T-48 to read the bioschip (using select chip as type XM25QH256B @WSON8, read somewhere...
                          02-24-2025, 04:46 AM
                        • jbonavita
                          ASUS TP500LA BIOS request/repair/merge?
                          by jbonavita
                          Hi, my laptop wont boot at all
                          With original bios no POST, only LED lights
                          With alternative BIOS from model TP500LN (flashed via programmer) the notebook works again
                          Some issues
                          A- with bios from 500LN, it won't update from bios of model 500LA (from 500LN v203 to 500LA v300)
                          B- If updated from 500LN version 203 to 300, the battery stops being recognized

                          Things I tried

                          1- Update / clear ME: Took the non working bios, made a backup, and did this: https://www.badcaps.net/forum/troubl...theory/trouble...
                          04-29-2025, 09:38 PM
                        • DynaxSC
                          Need real mobo dump of BIOS v402 for ASUS PRIME Z590-A - stock image no help
                          by DynaxSC
                          Hi,

                          I have a serious problem to program the Z590 chipset SRAM with a Management Engine after replacing the chipset.
                          The new chipset is factory new and is not containing any Management Engine. Any attempts to program it into the chipset under Windows ends with a failure (eg. Error 20: Management Engine Device not present, or something similar).
                          Due to the lack of the ME several ports on the board, including all M.2 ports aren't working, booting OS works only on USB. So it's now other way, as to program the chipset with a ME.

                          Usually on ASUS boards it worked...
                          06-14-2024, 03:49 PM
                        • Loading...
                        • No more items.
                        Working...