Asus f15 Fa506 no screen BQ24780s

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • greg1985
    Member
    • Oct 2023
    • 14
    • Polska
    #1

    Asus f15 Fa506 no screen BQ24780s

    Hi to All. Problem with laptop is no screen after power up. I have changes bios software many times and there is new bios chip also. Laptop still coming on with no picture.
    Every power line is present.
    I have noticed that in off Mode laptop take 7mA and then 10 to 16mA and coming back. Was interesting what is taking this current. Bq24780 is flickering. I check there is 2.6v, 6v, 18v present. Baterry is charging. What could be problem then? When i remove bios chip laptop takes 7mA only. Could be bios issue still or next step is kbc?
    Tags: None
    • greg1985
      Member
      • Oct 2023
      • 14
      • Polska
      #2
      This is third BQ ic tested and still the same

        Comment

        • mon2
          Badcaps Legend
          • Dec 2019
          • 14206
          • Canada
          #3
          Bq24780 is flickering.
          Can you clarify this comment? Which exact battery charger IC was onboard the original logic board?

            Comment

            • greg1985
              Member
              • Oct 2023
              • 14
              • Polska
              #4
              When laptop is connect to power, under thermal camera bq ic get hot, pulsuating. power supply shows 7 to 16mA. Also I've noticed strange voltage on BATFET gate - from 6.5 to 8volts and changing. There should be voltage from BQ ic connected by 4kohm resistor. But i dont know why this gate voltage changing.

                Comment

                • greg1985
                  Member
                  • Oct 2023
                  • 14
                  • Polska
                  #5
                  Orginal is Bq24780s.

                    Comment

                    • mon2
                      Badcaps Legend
                      • Dec 2019
                      • 14206
                      • Canada
                      #6
                      Part should not be heating up.

                      1) Soldered in properly? Pin #1 to pin #1 on PCB? No solder shorts?
                      2) Some offending interconnect is causing this fault. Flux and remove the batfet to test if the issue is resolved. Perhaps leaking?

                        Comment

                        • greg1985
                          Member
                          • Oct 2023
                          • 14
                          • Polska
                          #7
                          Thank You for response. Yes i will do that. My next idea is also to take another laptop (diffrent company) but with the same BQ ic and check pin voltages also.

                            Comment

                            • mcplslg123
                              Badcaps Legend
                              • Jun 2015
                              • 7262
                              • india
                              #8
                              If battery is charging fine,BQ24780S is unlikely to be faulty.

                              Check powergood signals one by one.

                              Mention the voltages on all coils after powering on.

                              All_SYS_PWR_Good is present?

                                Comment

                                • greg1985
                                  Member
                                  • Oct 2023
                                  • 14
                                  • Polska
                                  #9
                                  Thank You for reply. Update is: oscillating voltages on bq ic could be normal. Found on other forum voltages but not sure for 100%.

                                    Comment

                                    • Sametbey
                                      Badcaps Veteran
                                      • Jan 2021
                                      • 229
                                      • Turkey
                                      #10
                                      It was taken from a working device, it may help.
                                      Attached Files
                                      I'm not happy to be so strong. because it's not humanly

                                        Comment

                                        • greg1985
                                          Member
                                          • Oct 2023
                                          • 14
                                          • Polska
                                          #11
                                          Thank You.

                                            Comment

                                            • greg1985
                                              Member
                                              • Oct 2023
                                              • 14
                                              • Polska
                                              #12
                                              Update. Found missing resistor line 1.8v_gpu_aon.
                                              Closed. Thanks for help.

                                                Comment

                                                Previous template Next

                                                Related Topics

                                                Collapse
                                                • Ryan.man
                                                  Macbook 2017 with touchbar (A1706) won't turn on after removing the screen
                                                  by Ryan.man
                                                  Hello everybody! Posting this in hopes somebody has some expertise that leads to a clear path of troubleshooting that saves me a lot of time!

                                                  My macbook has the flex cable problem, the one that prevents the screen turning on. Ive been dealing with this for the last 3 years. Last year it went dead and I managed to fix it following youtube tutorials. But my fix wasnt the best, the problem returned a month later. This week, it went dead again. I again tried to fix it.

                                                  This time the original cable broke too close to the screen, it can't be fixed without tearing the screen...
                                                  02-04-2025, 12:23 PM
                                                • FallenOne008
                                                  Asus G712L No Screen Backlight
                                                  by FallenOne008
                                                  Hi everyone, hope all is well. I have run into a problem where my backlight screen is no longer working.

                                                  The original screen was beginning to show signs of faultiness. I believe it was part of the inverter board that was going bad. The backlight for the screen was still functional at this point. Well one night as I was tinkering with the laptop, my idiot self forgot to disconnect the battery from the motherboard. I attempted to reconnect the EDP cable onto the motherboard, and as you might guess, I saw a nice spark from the cable and the port. Don't worry, I'm still kicking myself...
                                                  03-31-2025, 08:27 PM
                                                • reformatt
                                                  Macbook Air M2 A2681 Kernel panics after screen replacement
                                                  by reformatt
                                                  Just had a customer bring in a M2 MBA A2681 that had had a screen replacement in April at another repairer. Since then, she has been getting intermittent kernel panics. It's an aftermarket screen, and of course it fails in diagnostics as the calibration hasn't been done. The error in the panic log is "No device added after powering on the rails".

                                                  It seems the original repairer has swapped the board and the screen to other MAC's, and said that it isn't a screen issue. From what I understand, by doing a quick search on Google, this is in fact a screen issue. The panic relates...
                                                  07-31-2025, 08:37 PM
                                                • krige
                                                  asus g750js ms1130c (203) turns on nothing on the screen
                                                  by krige
                                                  hi all i was wondering if you could help me troubleshoot this laptop. i bought the motherboard off eBay. it is used. i fitted the motherboard into the housing of the gaming casing and turned it on. nothing shows up on the screen. i checked the connectors and no missing connectors. i also removed the graphics card and nothing on the screen. i even reflashed the bios but still nothing on the screen. can it be a corrupt bios? i even used the HDMI port but it also shows nothing on screen. could this be broken screen or a dead ec chip?...
                                                  03-22-2024, 04:59 AM
                                                • Technodoc
                                                  ASUS G614JZ-N3012W Rog Strix need some bios help, laptop black screen
                                                  by Technodoc
                                                  Asus laptop G614JZ-N3012W Rog Strix with i7

                                                  Mainboard G634J-PMV-VGT
                                                  6050A3441302-MB-A01
                                                  2023-02-10

                                                  Power button works okay....power light goes on
                                                  Red "bottom" leds go on
                                                  Charging led works

                                                  Fans do not spin, capslock key does nothing, screen stays black

                                                  I would like to program the bios again, to rule out a corrupted bios.
                                                  However I run into a size error

                                                  The bios chip is a Winbond 25R256JVEN
                                                  Used my Xgecu T-48 to read the bioschip (using select chip as type XM25QH256B @WSON8, read somewhere...
                                                  02-24-2025, 04:46 AM
                                                • Loading...
                                                • No more items.
                                                Working...