Delphi MT60 Car ECU Revisit - No activity on CPU

Collapse
X
Collapse
 
  • Page of 2
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • Gjackson
    Senior Member
    • Aug 2021
    • 134
    • Malta
    #21
    Re: Delphi MT60 Car ECU Revisit - No activity on CPU

    Thank you, really informative.

    I guess what's left is trying it out in the vehicle and hoping it works, I'll keep you guys updated.

    Thanks for the help.

      Comment

      Previous 1 2 template Next

      Related Topics

      Collapse
      • Raven7032
        Dell G15 Ryzen Edition (LA-K454P) – No SPI Activity, No Boot, No startup
        by Raven7032
        Hello everyone!
        Stucked with this problem.
        Model: Dell G15 Ryzen Edition
        Board: GDL LA-K454P
        Symptoms:
        • Board powers on (consumption ~0.5A), but no boot or display.
        • Fans spin briefly, keyboard backlight turns on, then fans stop.
        • Can be shut down via power button (EC active).
        • No POST, no BIOS splash, no backlight.
        • Led is blinking 2 orange 1 white
        • No activity on SPI bus (no CS#, no CLK, no MOSI/MISO) even after pressing power.
        • No APU_PCIE_RST# - 0V
        Measurements:
        • All voltage rails present: +1.8V, +0.75V, +3VS, +5VS, VDDCR_VDD, VDDCR_SOC, DDR VDDQ, VTT.
        • EC_RSMRST#
        ...
        06-26-2025, 11:47 PM
      • corrize
        Resonator - quartz broken - how to find the same (same frequency) ?
        by corrize
        Hello, I have a Fujifilm hybrid camera with an issue : the time don't run. I set 12:00 and 3 min later, the same : 12:00
        I saw an obvious root cause : a broken quartz (resonator). But with the box broken, I can't read the marking code. Probably : 464… or A64…
        I found on the web a picture of the same camera board but with marking code very different. Probably : A7…5N
        I'm searching another one for compare…
        Do you have an idea or another way for find the frequency of this resonator please ?
        (I did not found the manufacturer of this component ? And I did not found the...
        03-27-2025, 09:20 PM
      • Aimbit
        Xbox One Controller - Phantom stick activity (sticks completely uninstalled)
        by Aimbit
        Hi All,

        I bought some used Xbox one controllers "as is/untested" and they both have the same issue. The joysticks go wild for no reason while plugged in.

        https://youtube.com/shorts/YTYtjUPkBX0?feature=share

        I removed both joysticks assuming it was an issue with the sticks, but the video posted here is the activity of the sticks with no sticks installed! My only guess is one of the tiny IC's that reads the inputs is broken. There are two small ones near either joystick, and then one larger one. I found a replacement on Aliexpress for the larger one...
        02-15-2024, 11:26 PM
      • rddube
        Delphi 28242585 radio power supply section
        by rddube
        Hello everyone,

        Trying to identify what the chip in the photo is. It is a component in the power supply section of a Delphi radio model 28242585 which is in a Volskwagen Jetta. Pin 1 is measuring 198 ohms to ground so I think I might have to change it.

        Does anyone know what this is ?


        Thank you!...
        09-23-2023, 05:15 PM
      • Gjackson
        Delphi MT60 Car ECU low resistance CAN/L/H to GND
        by Gjackson
        Hi all,

        I have a delphi MT60 car ECU which has no communication, dashboard fails to light up and so does the car. With all other devices unplugged and the ECU on my bench I powered it and tested the CAN lines, 2.5v solid on each with no activity seen on my scope. Resistance between CAN lines and ground Is 18k for both which is unusuall, I found some sources stating to reball a gate array IC found inside the ECU which I did but resistance didn't change.

        Any ideas? Thanks
        08-04-2023, 03:08 AM
      • Loading...
      • No more items.
      Working...