Hi guys ,
I "bought" this nice looking Bosch dryer for a 6 pack beer.
It has the problem that it is not heating anymore. ( Fan is working ).
I measured the thermostats inside and they are all ok. It has 1 thermo with the fuse that can pop out but its still fine.
So i got down to the heating element and it has no continuity/endless ohm so i know its bad.
I got a question , can i make this element work again temporarily? I got continuity on the outer part of the element but not on the pins itself. If i look closely on the pins i notice that there are 2 small pins inside the element. So i guess something on the inside is broken.
What happens if i solder the pins to the outer part of the element?
Anyone have experience with this type of dryer?
I "bought" this nice looking Bosch dryer for a 6 pack beer.
It has the problem that it is not heating anymore. ( Fan is working ).
I measured the thermostats inside and they are all ok. It has 1 thermo with the fuse that can pop out but its still fine.
So i got down to the heating element and it has no continuity/endless ohm so i know its bad.
I got a question , can i make this element work again temporarily? I got continuity on the outer part of the element but not on the pins itself. If i look closely on the pins i notice that there are 2 small pins inside the element. So i guess something on the inside is broken.
What happens if i solder the pins to the outer part of the element?
Anyone have experience with this type of dryer?
Comment