Anyone worked on a auto dishwasher board with any degree of success?
They is too expensive to replace.
They is too expensive to replace.
-
939 DualCore AMD Opteron, 1800 MHz (9 x 200)
Abit AN8 / Fatal1ty AN8 SLI Series
3072 MB (PC3200 DDR SDRAM)
ATI Radeon HD 4300/4500 Series (1024 MB
Lian LI Aluminium mesh case -
Re: um...dishwasher?
'Auto' dishwasher...?
Is this just a standard kitchen dishwasher?
What board, what's wrong with it? Make & model, PICTURES! -
Re: um...dishwasher?
I recommend marriage counseling. Divorces are expensive, you're right there.Ludicrous gibs!
Comment
-
Re: um...dishwasher?
try www.partselect.com or
www.repairclinic.com or
www.appliancepartspros.com
for parts.
There use to be a whirpool site that had all their brands' service manuals available for free. But alas the b*%tards made it paid subscription only starting oct 1. I won't help them out by linking to it.Comment
-
Re: um...dishwasher?
Its a Simpson Silencio 972
It wont progress past pre-wash just sits looking dumb with a a light cycling.
I had the door cover off just a simple looking board, will take a photo later
939 DualCore AMD Opteron, 1800 MHz (9 x 200)
Abit AN8 / Fatal1ty AN8 SLI Series
3072 MB (PC3200 DDR SDRAM)
ATI Radeon HD 4300/4500 Series (1024 MB
Lian LI Aluminium mesh caseComment
-
Re: um...dishwasher?
The dishwasher is trying to tell you something! My Googleing didn't get my far though.
I found manuals for the 850, here: http://www.cs.usyd.edu.au/~jstavrak/simpson_dishwasher/
You can try contacting Simpson, but if they're anything like Hotpoint, they'll tell you to look at an FAQ that doesn't help. They might give you a manual!
In the case of my Hotpoint washing machine - the filter was blocked, resulting in the mini load and reduced crease light flashing, because the pump couldn't move the water.Comment
-
Re: um...dishwasher?
Thank you seanc. My machine appears to be close to the 980
Here is dishwasher central. I love to know what them wires lead to....
939 DualCore AMD Opteron, 1800 MHz (9 x 200)
Abit AN8 / Fatal1ty AN8 SLI Series
3072 MB (PC3200 DDR SDRAM)
ATI Radeon HD 4300/4500 Series (1024 MB
Lian LI Aluminium mesh caseComment
-
Re: um...dishwasher?
There's two boards, with an intermediate board, connected with resistors? Interesting.
All I would do at the moment is check ESR of caps and solder joints.
I'd be more interested in finding the meaning of the flashing light - it means something.Comment
-
Re: um...dishwasher?
This might help a little:
SIMPSON SILENCIO 972 DISHWASHER => Model: 52B972WE*01
- from: http://spares.alliedappliance.com.au...4_3_10_73.html
Parts houses will probably use 52B972WE*01
No luck on a drawing.
I'm kind'a thinkin' bad transistor, or one not working due to bad supporting part.
.Mann-Made Global Warming.
- We should be more concerned about the Intellectual Climate.
-
Be who you are and say what you feel, because those who mind don't matter and those who matter don't mind.
- Dr Seuss
-
You can teach a man to fish and feed him for life, but if he can't handle sushi you must also teach him to cook.
-
Comment
-
Re: um...dishwasher?
talking about work like we do sometimes. that kind of stuff has some potential. most plumbers/home techs i know their abilities dont extend to board repair. get a few of them as client and bingo.Comment
-
Re: um...dishwasher?
Are you sure the physical parts are OK. It might not progress because something else is wrong. The board does show corrosion. Check all connections and then transistors.Comment
-
Re: um...dishwasher?
I'd look at the interlock safety switches. Next I'd look at the pump. What about the stain on the choke there? Is it fried?Last edited by Junk Parts; 10-15-2010, 03:08 PM."It ain't what you don't know that gets you into trouble. It's what you know for sure that just ain't so."
Mark Twain
"I wish to have no connection with any ship that does not sail fast; for I intend to go in harm's way."
John Paul Jones
There is a fifth dimension, beyond that which is known to man. It is a dimension as vast as space and as timeless as infinity. It is the middle ground between light and shadow, between science and superstition, and it lies between the pit of man's fears and the summit of his knowledge. This is the dimension of imagination. It is an area which we call the Twilight Zone.
Rod SerlingComment
-
Mann-Made Global Warming.
- We should be more concerned about the Intellectual Climate.
-
Be who you are and say what you feel, because those who mind don't matter and those who matter don't mind.
- Dr Seuss
-
You can teach a man to fish and feed him for life, but if he can't handle sushi you must also teach him to cook.
-
Comment
-
Re: um...dishwasher?
99% of the time with these types of gear it's not the board.
check the pump filter and any pressure sensors - if they have small hoses linking them you need to check the hoses arent blocked by crap or scale.
i'v done some washing machines and it's always some sensor or other mechanical part.Comment
-
Re: um...dishwasher?
Originally posted by PCBONEZDon't want to sound like "me too", but both these are right on track.Originally posted by stj
A bad or blocked line when it goes to pump out will kick it into shutoff. A door switch or interlock would prevent it from even working. A failure in the "brain" is not usually picky and would not let it even begin to function correctly.
Listen to it and see if you can detect what it tries to do when it fails. Does the motor do the first cycle then stop then start again and shutdown? That would usually point right at a blocked or restricted drain, and a sensor has prevented that. These reverse motor direction to pump out.
I had one where a screw came loose and was in the pump. Cycled fine until pump out. Then it sounded like a coffee grinder.
You'll figure it out eventually, but I don't think you are having a control board problem.
Or, you'll call the repairman...
QLast edited by Quasar; 10-15-2010, 09:50 PM.Comment
-
Re: um...dishwasher?
Thanks everyone for your help
I got a day on it tomorrow will check everything I can that you have suggested
I rescued it from the tip was on neighbours frontage awaitin collection, I think it will make a half decent home brew bottle steriliser
Meantime putting together latest board, Fatal1ty AN8 SLI 939 with an Opteron 165
BTW I went over some soldering on caps on an EPOX board with my big bad boy iron. Not only did it start without faffing about, but the CPU runs 20C coolerLast edited by kiddznet; 10-16-2010, 02:20 AM.
939 DualCore AMD Opteron, 1800 MHz (9 x 200)
Abit AN8 / Fatal1ty AN8 SLI Series
3072 MB (PC3200 DDR SDRAM)
ATI Radeon HD 4300/4500 Series (1024 MB
Lian LI Aluminium mesh caseComment
-
Re: um...dishwasher?
Well now to add to my problems the Fatal1ty wont start. In fact it does not do much. No LED display only little red winking LEDS near the GURU pins I took out the 24 pin connecter and hooked it up to a tester and the board lights near the VRM came on with the 4 pin plug still in. The PSU tested fine but no life from the board
Oh...when I unpacked it someone had left off the CMOS jumper. I put another one on cleared this and put in new battery
Just out of curiosity would this board run with that jumper missing?
AN8-SLI 939 socket
939 DualCore AMD Opteron, 1800 MHz (9 x 200)
Abit AN8 / Fatal1ty AN8 SLI Series
3072 MB (PC3200 DDR SDRAM)
ATI Radeon HD 4300/4500 Series (1024 MB
Lian LI Aluminium mesh caseComment
-
Re: um...dishwasher?
Yes it will run with the jumper missing. You have another problem.A working TV? How boring!Originally posted by PeteS in CAComment
-
Re: um...dishwasher?
Thank you Th3.
I will try another PSU today but I dont like the look of it
939 DualCore AMD Opteron, 1800 MHz (9 x 200)
Abit AN8 / Fatal1ty AN8 SLI Series
3072 MB (PC3200 DDR SDRAM)
ATI Radeon HD 4300/4500 Series (1024 MB
Lian LI Aluminium mesh caseComment
-
Re: um...dishwasher?
I don't think modding you dishwasher with a motherboard will get the dishes any cleaner.
.Mann-Made Global Warming.
- We should be more concerned about the Intellectual Climate.
-
Be who you are and say what you feel, because those who mind don't matter and those who matter don't mind.
- Dr Seuss
-
You can teach a man to fish and feed him for life, but if he can't handle sushi you must also teach him to cook.
-
Comment
-
Hi Everyone,
I have a Lenovo G50-80 that auto powers On when AC (Charger) is connected. I have checked the BIOS settings and there is no option to turn On or Off that feature as it is in some HP EliteBooks. I did update the BIOS and still same.
I then flashed the BIOS with a different bin file I downloaded here, It worked (didn't auto power on) for some time (after testing up to 5 times) but has now started again to auto power on when AC is connected.
The CMOS battery voltage is 3v. I have also tested with two main batteries as well. I would be glad if anyone... -
Hi guys, can someone help me?
I have an issue with laptop dell latitude e5490 that auto restart when arrive at certain point in loading windows.
Board model is dm70 la-f401p rev:1.0 2017-09-20.
At first, the issue is sometime ssd sata 2.5 not detected. i already try another cable, at certain point, it ok using old cable (i mean sata cable here).
After a few days test, is seems ok.
Days later, another issue come, that is auto restart when certain point in loading windows. i already test another ssd, another ram, another sata ribbon, still same.... -
My friend has a evga rtx 2080 super, and with liquid cool backplate. I installed for him. 4 month ago it runs good, and recently idk if he played with msi afterburner or not, the gpu slow it's core frequency when it's over 60 degree. I reset setting in msi afterburner, still the same.
here is a video of it running stress test, the usage is always 100% for sure, but core frenquency drop to 300mhz (should be over 1600mhz normally), when it hit 60 degree.
https://imgur.com/a/gLMfJid
at very beginning of stress test, the frequecy can reach 1600+, but as... -
Just wanted to get some feedback,
whats peoples' success rate with cof bonding repairs..... -
Hi!
Went dumpster-diving and found a bricked Lenovo P14S in trash, few weeks earlier. Symptoms - no screen, no POST, no beep, just keyboard LEDs flashing on powerup. Mute button+LED was responding though, and the display self-test was still working (via the key combo Ctrl+Fn+Power held for some seconds, see the Service manual).
Incidentally, Windows 11 have recently started auto-flashing computer BIOS in our region. Even more suspiciously, Lenovo has released a BIOS update just few days before the PC was trashed. About a week later, the BIOS update image has been oficially marked...04-14-2025, 01:56 PM
Comment