Does any one have any opinions on the Siglent SDS2352X-E scope, are they reliable? I almost got the 300Mhz 2Ch Rigol, it seems Siglent has the edge.
Dave
Dave
-
-
Re: Siglent SDS2352X-E scope?
Rigol seems have have sat on their laurels for a few years. I have read good reviews of Siglent's scopes, but I don't have one, and no experience with one. I'm possibly in the market as well, so I'll be watching this thread also. -
Re: Siglent SDS2352X-E scope?
rigol has new models, but they arent low-end
(or cheap)Comment
-
Re: Siglent SDS2352X-E scope?
What kinda put me of Rigol was three things..... the screen is screen glare and you got to look at it at an angle so I was told, the measurements is over part the waveform and as clearchris said they sat on their laurels.
I only need a 2 Ch. scope no need for an high end one, maybe they might updates the lower cost one to keep up with their competitors.... that's the reason I've learned they're giving free updates, the only thing's I can see is the Rigol has a better memory depth, maybe updating their lower end is on the horizon.
Here's a review https://www.youtube.com/watch?v=7zJ8X51l0Go, what struck out was the bandwidth test.
DaveComment
-
I am attempting to test a samsung power supply board to verify the pfc ic is working. I am powering up the board with my isolation transformer. The board turns on fine but when I attempt to connect the ground for the scope probe, it trips out the isolator. I was taught not to 'float my scope' so I am wondering if I should test without connecting the ground lead or would that be asking for trouble? Not sure how else to test, I don't have a portable scope. I could plug direct to mains power but that would bypass the safety factor.
-
I have a 40 volt AC transformer that I put a bridge rectifier on, and I wanted to see the input signal and the output signal on the same screen on my scope, so I set one channel up with the test lead on one side of the input and the ground lead on the other side of the input, then I used another channel on the scope and clipped the test lead on the positive side of the output then the ground on the negative side of the output.
When I connected the transformer to power, the wire that was connected between the ground lead on the second channel and the negative side of the bridge rectifier... -
I thinking about about buying one later on this year depending on what feedback I get from this forum members that know more than I do about what is importance about what to have in a scope
https://www.aliexpress.us/item/32568...3333736563%21s... -
All,
Some of you have helped me in the past and I am very appreciative of all the help! (I have fixed TVs/Stereos/ and other small appliances with your efforts...Thanks so much!!!
Today I went to a local HAM Radio Festival. It was one of the smaller ones in our area. My stepfather is the HAM operator. I tinker in electronics but am a Software Programmer (27 years now).
I was looking for a few odds and ends for some electronics work I have to do for the household/farm. Typically these type of shows have the grab bags or a electronics vendor... -
Hi all,
First time trying to fix a TV for a friend, it's a Bush DLED32165HD.
Power Board - 17IPS11
Mainboard - 17MBS82S
Panel - VES315WNDB-02
Red blinking standby light is on steady, press power button on remote and light flashes 7 times then stays steady, press power on remote again light flashes 10 times and then goes off.
Checked all the voltages on the power board inc backlight circuit, they all read ok and are stable. Backlights tested with backlight tester and all work fine (2 strips x11LED on each).
No picture, backlight or sound just blinking...
Comment