Hi Folks
I have a shredder, the problem is after putting the paper it takes about a minute for the motor to start and shred.
I trouble shooted a lot and figured out that the problem is the voltage at the coil end of the relay is taking time to reach 24V. It rises very gradually and as soon as it reaches 20V the motor starts.
The question is what component could be causing this ? Could caps be the problem. Please see PCB images below
I have a shredder, the problem is after putting the paper it takes about a minute for the motor to start and shred.
I trouble shooted a lot and figured out that the problem is the voltage at the coil end of the relay is taking time to reach 24V. It rises very gradually and as soon as it reaches 20V the motor starts.
The question is what component could be causing this ? Could caps be the problem. Please see PCB images below
Comment