UN55C8000 lines

Collapse
X
Collapse
+ More Options
Posts
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • joystik
    Member
    • Jun 2016
    • 20
    • Colombia
    #1

    UN55C8000 lines

    Hi.

    Tried troubleshooting this TV, however after changing the Tcon, still the same.
    Any ideas of what should I look at?
    Attached Files
    Tags: None
    • CapLeaker
      Leaking Member
      • Dec 2014
      • 7990
      • Canada
      #2
      Re: UN55C8000 lines

      Tab bonds

        Comment

        • nomoresonys
          Badcaps Legend
          • Jan 2013
          • 12085
          • U.S.
          #3
          Re: UN55C8000 lines

          Looks like it, give the bezel NOT the screen a squeeze or a light tap there where the lines end see if they change any.
          Last edited by nomoresonys; 06-09-2018, 04:27 PM.

            Comment

            Previous template Next

            Related Topics

            Collapse
            • advant
              Driving a Sharp TCON/panel with a universal main board
              by advant
              This thread is about trying to get an Universal Main Board to work with a Sharp TCON and panel.

              I have a Sharp LC-46D85UN TV that has had a main board issue. Since this model is from 2009, I am not able to find an exact replacement of the main board. Instead, I decided to see if I can future proof this tv by getting a Universal Main Board (T53U21.2) from China to work with the Sharp TCON (CPWBX4291TPZA) and panel. The universal main board supports a 8 bit dual channel LVDS interface whereas the TCON requires a 10 bit dual channel LVDS input. I have modded the LVDS connector to match...
              02-03-2020, 12:25 AM
            • Stanley1843
              Screen Display Vertical Multicolor Lines
              by Stanley1843
              Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesnโ€™t display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed...
              06-29-2024, 11:54 AM
            • Daren87
              Sony 8K XBR-75Z8H White Screen Vertical Bars Tcon Code. Help Needed๐Ÿ™
              by Daren87
              Hello everyone,

              I've recently been given a Sony 8k Z8H. It's got a white screen with two vertical black bars. At times it's given me the 5 blink Tcon code. Testing voltage on the Tcon I can see some low or missing voltage. I've done a basic visual check of cables and the COF. Not seeing anything obvious. The original Tcon seemed to have good caps until turning it over. On the bottom I found maybe 10 caps with both sides of the caps shorting to ground. I thought ok these caps and likely other components on the Tcon are shorted so let's try a replacement Tcon. I just received the...
              08-13-2023, 03:25 PM
            • x_orange90_x
              TCL 50S535 bad tcon or panel issue?
              by x_orange90_x
              Just bought this for 10 bucks yesterday hoping to fix it. The guy said water dropped inside from a dehumidifier hose and it started showing black and white vertical bars then went blank. When I got it home and turned it on it came on fine and displayed correctly but I was noticing faint vertical bars in the image. After a little bit I turned it off and back on and it was a black screen again. I opened it up to check for water damage and corrosion but didn't find anything of the sort. I cleaned the ribbons anyway and reconnected them but still got a blank screen. If I disconnect the right side...
              03-29-2025, 11:02 PM
            • Awsmessymail
              Vizio E701i-A3 backlight only and now no backlight
              by Awsmessymail
              Hello all,
              Iโ€™ve tried to repair TVs in the past with some luck. Toms repair manuals got taken down and now thats a bit harder.
              I picked this TV up hoping for a quick fix. When the TV would power on, only the backlights would come on. The owner told me they heard loud screeching before it shut off. This alone makes me want to think the main board has an issue.
              As I researched, I found the TCON/driver boards were an issue on this unit. I went in troubleshooting the TCON but found good voltages on the TCON. I followed shop jimmys guide to test the transistors and they seem okay....
              CN201 on power supply
              5 Photos
              02-13-2024, 11:04 PM
            • Loading...
            • No more items.
            Working...