Panasonic Plasma - different YSUS board rev

[meciu]

Hello three.

I have a broken plasma TX-P42G15E with 5 LED blinks and I've purchased used and working YSUS board but it is a bit different than mine..
I've got broken TNPA4844AH and purchased TNPA4844AD from TX-P42G10E

And my question is.. swapping board will work? Or I need to solder additional components from my broken board?

Thanks!

[Moreno83]

Re: Panasonic Plasma - different YSUS board rev

It will probably work! Do you see any different components on the board?.

[Moreno83]

Re: Panasonic Plasma - different YSUS board rev

Also , there is a great chance that the panel is exactly the same.

[meciu]

Re: Panasonic Plasma - different YSUS board rev

@Moreno83

So at this moment I see a few differences with caps and this blue things..

picture in attachment

[tom66]

Re: Panasonic Plasma - different YSUS board rev

You may have an issue if the other board is from a 46" or 50" panel. This could cause maldischarge (colour distortion, stuck pixels, image retention) or other faults, and may lead to the new board failing.

[Lloyd6202]

Re: Panasonic Plasma - different YSUS board rev

Take those two components out and be done with it...u shouldnt have a problem then

[tw2005]

Re: Panasonic Plasma - different YSUS board rev

I just did this myself but in the reverse. Used G15 SC for a G10. The panel part numbers were the same. I don't know if you can access Shopjimmy but a reverse search on APnel MC106F16T12 shows both those revisions fitted.
Based on that, I would simply fit and forget. I did.