Eeprom dump thread!

[digitel]

Please, do you have the firmware for a Hitachi 43HAE4251 TV, with Mainboard 17MB171 and Panel VES430UNDH-N2-N45? The memory is not SPI Flash. It's EMMc. Thank you.

[luzmina]

Here is the dump for the Hisense 70H6570G and 70A6G. It fixed the corrupted EMMC issue that put the TV into a loop.
Board RSAG7.820.9783/ROH
https://drive.google.com/file/d/129h...usp=drive_link

[Salvatore Cancellieri]

Hi everyone, I have a 65" Philips TV, it turns on and after a while it restarts endlessly, I checked the power supply and everything is ok, I disconnected all the devices and the panel but it continues to restart, I assume it is a dump problem, below is the original dump
TV model 65PUS6523/12
Board model 703TQHPL433 715G8709-M0B-B01-005K

Thanks

[lotas]

it works.
than you very much

That's good.

[dinche_ze]

Try.

it works.
than you very much

[lotas]

Pozdrav prijatelji,
imam Toshiba 32el933g TV. Samo crveno svjetlo svijetli, ne pali se ni ništa. Kada sam ažurirao firmware, otkrio sam da se TV uključuje, ali nema slike. Mislim da se matrica ne podudara. Moja matrica je LG. Za drugu ne znam. Objavit ću originalni firmware od TV-a i novi ako netko zna kako ih uskladiti.

Try.

[dinche_ze]

Pozdrav prijatelji,
imam Toshiba 32el933g TV. Samo crveno svjetlo svijetli, ne pali se ni ništa. Kada sam ažurirao firmware, otkrio sam da se TV uključuje, ali nema slike. Mislim da se matrica ne podudara. Moja matrica je LG. Za drugu ne znam. Objavit ću originalni firmware od TV-a i novi ako netko zna kako ih uskladiti.

[lotas]

Thanks Lotas it worked a treat

Ok!

[cheeky2]

Try this dump, but the panel is unknown.

Thanks Lotas it worked a treat

[dinche_ze]

So what does the firmware have to do with it? If it doesn't work for you via the remote control, check the remote control, try via a universal remote control. If it doesn't work, replace the IR receiver, make sure the pulses reach the processor...

probao sam, ispravan daljinski, nece ni univerzalni. a ir prijemnik sa 4 pina,( 2 gnd, na jednom stalnih 5V, a na drugom 5V koji opada na 3,5V kada koristim daljinski), nemam takav ir da bi testirao ,mada sumnjam da je do njeg jer reaguje

[lotas]

problem is that remote control is not working, other things works fine.

So what does the firmware have to do with it? If it doesn't work for you via the remote control, check the remote control, try via a universal remote control. If it doesn't work, replace the IR receiver, make sure the pulses reach the processor...

[dinche_ze]

Post here your original, non-working dump, I'll try to fix it.

problem is that remote control is not working, other things works fine.

[lotas]

Post here your original, non-working dump, I'll try to fix it.

[dinche_ze]

Don't you know the motherboard number either?

[lotas]

hello friend
I need spi flash for TESLA TV
model: 43S306BF
dont know matric number

Don't you know the motherboard number either?

[dinche_ze]

hello friend
I need spi flash for TESLA TV
model: 43S306BF
dont know matric number

[cheeky2]

Try this dump, but the panel is unknown.

Thanks I will give it a go over the next few days and let you know the results

[lotas]

Looking for a working dump for the following Bush TV
Model: BUSH LE-40GCL-A1
Main: TP.SIS231.PT751
Screen: V400HJ6-PE1
Attached is the faulty dump from the TV.
Thanks for any help

Try this dump, but the panel is unknown.

[cheeky2]

Looking for a working dump for the following Bush TV
Model: BUSH LE-40GCL-A1
Main: TP.SIS231.PT751
Screen: V400HJ6-PE1
Attached is the faulty dump from the TV.
Thanks for any help

[porfyriadhs]

VES315UNGB-L3-N53 screen model