Sony LC-60SQ15U looking for LED backlight part #s

[aasnowskate]

I am looking for part numbers for the backlights on a sony LC-60SQ15U.
I have a one long blink, one short blink code coming from the light. I have tried the reset system procedure and it did not help.
I have narrowed it down to a bad LED strip. I can not find the led strips for this set by searching by model # anywhere and am trying to look by the part #. I want to know if I can find them anywhere before completely taking TV apart because it is a very difficult process to take it all apart without damaging the display. I have learned from experience.
I did not post pics of boards, because I am not looking for a board repair.
Thank you in advance for your time.

[budm]

Re: Sony LC-60SQ15U looking for LED backlight part #s

That is not SONY model number.
You should go by the LCD panel model number to get the correct LED strips.

[ReeceyBurger123]

Re: Sony LC-60SQ15U looking for LED backlight part #s

Thats a sharp lol, also got image of the Leds used ?

[aasnowskate]

Re: Sony LC-60SQ15U looking for LED backlight part #s

Sorry, Sharp. I have a few things going on in the shop right now and looked at a sony as I was typing. The number on the panel is R1JE601D3GW00Z. I don't have pics of the strips because I don't want to take this thing apart without knowing if I can get the part.

[budm]

Re: Sony LC-60SQ15U looking for LED backlight part #s

Can we see the LCD panel number sticker? That number does not look right.

[aasnowskate]

Re: Sony LC-60SQ15U looking for LED backlight part #s

I added a pic of the boards since I was taking pictures.

[budm]

Re: Sony LC-60SQ15U looking for LED backlight part #s

OK, not much info out there for that LCD panel.
By the way, out of four LED strings, how many are bad?

[aasnowskate]

Re: Sony LC-60SQ15U looking for LED backlight part #s

Im not sure how many are bad. Again, I don't want to take it all apart because it is kind of an in depth process to do. Especially with a 60 inch.

[Alastair E]

Re: Sony LC-60SQ15U looking for LED backlight part #s

Dismantling is Unavoidable!

[budm]

Re: Sony LC-60SQ15U looking for LED backlight part #s

BTW, did you see the backlights even flash on for seconds?

[aasnowskate]

Re: Sony LC-60SQ15U looking for LED backlight part #s

I did not see the back lights flash. It is in a shut down mode. When it is plugged in, it just does the one long blink and one short blink from the power light. It is unresponsive.

[budm]

Re: Sony LC-60SQ15U looking for LED backlight part #s

I did not see the back lights flash. It is in a shut down mode. When it is plugged in, it just does the one long blink and one short blink from the power light. It is unresponsive.

It has four strings of LEDs so if one is bad, the rest still should light up and then the protection circuit will kick in.
So how did you figure out that you have bad LEDs?

Sharp RUNTKB109WJQZ (DPS-167CP A) Power Supply / LED Board
http://www.shopjimmy.com/sharp-runtk...-led-board.htm
Pictures provided by shopjimmy.

I would inspect and resolder the transformer legs, the legs of the devices attached to the heat sink.
Check and report the DCV reading of the connector PD, make sure to put the pin names with each reading.
Check and report the readings for the DCV between the two legs of the caps:
C7204, 7205, 7206, 7207, 7229A, 7229B.
This is done to verify that the power supply/LED driver board is good or not unless you are sure that the LED is bad then do not do any of those above.
I did not find the service manual to know what the blinking code means.

[SLK001]

Re: Sony LC-60SQ15U looking for LED backlight part #s

On a Sharp, you will need to do a "hard reset" to get it out of shutdown mode.