Toshiba 22dv713b No Backlight

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ReeceyBurger123
    Never Give Up !
    • May 2014
    • 7325
    • Britain

    #1

    Toshiba 22dv713b No Backlight

    Hello all, I have here a real Toshiba no vestel junk ! The issue today is that the backlight fires on but then shuts down. Normally I would suspect that there is a failing Ccfl lamp however upon hocking up two sets of know good lamps the fault is still the same the known good lamps all start fine then go off.
    Upon checking the "lamp error pin" its 3.3v at all times should it be ? The "blon" and "dim" voltages are all fine. This tv has the inverter built onto the Psu I have checked the Mosfets that drive the inverter and they are good so what could cause this any help is much appreciated thank you.
    Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

    https://www.facebook.com/Telford-Tel...7894576335359/
  • ReeceyBurger123
    Never Give Up !
    • May 2014
    • 7325
    • Britain

    #2
    Re: Toshiba 22dv713b No Backlight

    Fixed the set was a failed transformer after all turns out I measured it wrong. Will post youtube video on the fix soon.
    Please Do Not PM My Page Asking For Help Badcaps Is The Place For Advise, Page Linked For Business Reasons Only. Anyone Doing So Will Be Banned Instantly !

    https://www.facebook.com/Telford-Tel...7894576335359/

    Comment

    • vinceroger69
      Badcaps Legend
      • Mar 2012
      • 6714
      • uk

      #3
      Re: Toshiba 22dv713b No Backlight

      Nice cheap fix i didnt think the picture was too bad on these sets and the dvd drive seemed reliable too read all discs i had anyway, i think i sold mine for £60.00.

      Comment

      Related Topics

      Collapse

      • triplefour
        UN65TU700DF picture and sound but no backlight. BL tests ok but repl. PSU didnt fix!
        by triplefour
        this tv is throwing me for a loop. do samsung tvs no longer have the backlight self test feature built into the power supply?
        i tested the backlight with my LED tester and it lights up both strips. one of them reads 100v and the other reads 63.7v.
        unplugged mainboard from power supply but left backlight plugged in, and then plugged psu wall power in. expected to see backlights light up but see nothing.
        according to how ive diagnosed in the past, this would almost always be a bad power supply. replacement power supply was cheap like 20$ from ebay. but still i get not even...
        09-13-2023, 10:43 PM
      • Boyxba
        TOSHIBA BACKLIGHT MAINBOARD C55-a-1h9
        by Boyxba
        I have a toshiba laptop satelite series c55-a-1h9 with a burnt item on pcb motherboard which is responsible for backlight display. the short came after installation of cable lvds and broken the leg with the v+ of backlight and made this short . the lvds cable replaced and i have working display now but not backlight. the problem is i dont know what was the component that burned in order to change it. voltage i have in this points of burned item at up side 19v and dropping and from down i have steady 19v . can anyone help me? i shall post some photos to see....
        05-13-2023, 11:47 AM
      • DanPoka
        Guide me through repairing a Dell p2210f LCD ccfl backlight monitor
        by DanPoka
        I bought this p2210f dell monitor to fix. Schematic is the same as p2210.
        Behaviour is that monitors comes on but then backlight switches off almost instantly. If I look with flashlight I can still find the "No signal message". So definitely a backlight issue. Trying to advance the issue I proved that the protection circuit is switching off the backlight by shorting out C3 and resistor to disable the INL chip then re enable by removing the short.
        This is where it gets interesting. When I disassembled the monitor to solder leads on c3 capacitor I noticed the backlight flickered...
        02-15-2025, 05:05 AM
      • Comp_Pro
        No Backlight Macbook A1990 820-01041
        by Comp_Pro
        Hello all,

        Am trying to figure out this backlight issue with this A1990 Macbook Pro.

        Tests performed:

        There is no backlight even with a good screen.
        Backlight IC is receiving the correct support voltages.
        Fuse F8400 ok
        Current sense resistor R8400 ok
        Backlight IC is receiving 3.3V on enable pin.
        Backlight IC receiving voltage from PPBUS_G3H, aprox 12.5V.
        Backlight IC receiving 5V from PP5V_G3S
        Backlight IC BKLT_SCL and BKLT_SDA both measure 0.545V diode mode to ground
        I2C_BKLT_SCL and I2C_BKLT_SDA both measure...
        05-06-2024, 10:23 PM
      • willis6732
        Toshiba 55lf621c21 Dim Picture / Backlight afterbypassing a Burnt LED
        by willis6732
        Hello,

        This TV came in for a backlight Repair. I bypassed the Burnt LED as shown in Picture. I thought it was fixed and returned to customer. So I dont have the TV anymore, but customer says its not really watchable.

        Now the TV Is much dimmer than before. It does a quick bright flash when it first turns on.

        The Driver board looked pretty toasty in the LED Driver Area.

        So I am wondering.. how can i Tell if this is a LED or Driver Board Issue?...
        12-17-2024, 04:09 PM
      • Loading...
      • No more items.
      Working...