Samsung ln40a530p1fxza (white screen)

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Tfsjake
    Member
    • Jul 2015
    • 14
    • United States

    #1

    Samsung ln40a530p1fxza (white screen)

    Hey guys! I have done a little research and I haven't quite figured out what's going on with my TV.

    I have read that the older Samsungs have fuse problems on the T con board. I am just dangerous enough with a multimeter to mess something up, so I can take some readings if need be.

    When I turn the TV on it is either super, super white and/or a negative image (not solarization). I unplugged the t-con board completely and reinstalled it to have the image come in completely fine for <60 seconds and then go back to white. Attached are pictures of the screen and T-con board.
    Attached Files
    Last edited by Tfsjake; 07-22-2015, 10:19 AM.
  • budm
    Badcaps Legend
    • Feb 2010
    • 40746
    • USA

    #2
    Re: Samsung ln40a530p1fxza (white screen)

    This board is known for having bad AS-15 GAMMA ref Voltage IC problem that causes washed out pictures, see if that IC gets very hot to touch.
    .
    Never stop learning
    Basic LCD TV and Monitor troubleshooting guides.
    http://www.badcaps.net/forum/showthr...956#post305956

    Voltage Regulator (LDO) testing:
    http://www.badcaps.net/forum/showthr...999#post300999

    Inverter testing using old CFL:
    http://www.badcaps.net/forum/showthr...er+testing+cfl

    Tear down pictures : Hit the ">" Show Albums and stories" on the left side
    http://s807.photobucket.com/user/budm/library/

    TV Factory reset codes listing:
    http://www.badcaps.net/forum/showthread.php?t=24809

    Comment

    • Tfsjake
      Member
      • Jul 2015
      • 14
      • United States

      #3
      Re: Samsung ln40a530p1fxza (white screen)

      Originally posted by budm
      This board is known for having bad AS-15 GAMMA ref Voltage IC problem that causes washed out pictures, see if that IC gets very hot to touch.
      .
      Well holy crap. I've never been on a forum where the first answer was appropriate, concise, and accurate. That chip gets painfully hot after about 2 seconds of the TV being on.

      I own a soldering station and have minimal skill with that. I know that these require hot air to remove/replace, usually. So...what's my next step?

      Comment

      • budm
        Badcaps Legend
        • Feb 2010
        • 40746
        • USA

        #4
        Re: Samsung ln40a530p1fxza (white screen)

        Order the IC and carefully remove and install the new IC, those traces lifted off very easily so take your time doing the repair, if you are not good with soldering and do not have proper tools to do SMD rework, then have some one else with proper tool (hot air station) to do it for you.
        Never stop learning
        Basic LCD TV and Monitor troubleshooting guides.
        http://www.badcaps.net/forum/showthr...956#post305956

        Voltage Regulator (LDO) testing:
        http://www.badcaps.net/forum/showthr...999#post300999

        Inverter testing using old CFL:
        http://www.badcaps.net/forum/showthr...er+testing+cfl

        Tear down pictures : Hit the ">" Show Albums and stories" on the left side
        http://s807.photobucket.com/user/budm/library/

        TV Factory reset codes listing:
        http://www.badcaps.net/forum/showthread.php?t=24809

        Comment

        • Tfsjake
          Member
          • Jul 2015
          • 14
          • United States

          #5
          Re: Samsung ln40a530p1fxza (white screen)

          Thank you! Are there any services that will do this that I can mail the board to? I see that shopjimmy has a repair service but for $80 which is a good percentage of what I consider the TV to be worth to me.

          At that point would I be better to buy the entire board from eBay or somewhere similar? I thoroughly appreciate the help.

          Comment

          • Hamie
            Badcaps Legend
            • Apr 2014
            • 1383
            • UK

            #6
            Re: Samsung ln40a530p1fxza (white screen)

            A local repair shop, or computer repair shop should fit the chip for you for far less than $80.

            Comment

            • Tfsjake
              Member
              • Jul 2015
              • 14
              • United States

              #7
              Re: Samsung ln40a530p1fxza (white screen)

              Originally posted by Hamie
              A local repair shop, or computer repair shop should fit the chip for you for far less than $80.
              For some reason I thought the TV repair places would just swap boards/etc. Called a semi local one up (all the local ones had crappy reviews) and the guy said they can do it for ~20-30 if they supply the chip, and less if I supply it.

              Thanks guys, I'll up date this thread with the results!

              Comment

              • Tfsjake
                Member
                • Jul 2015
                • 14
                • United States

                #8
                Re: Samsung ln40a530p1fxza (white screen)

                So I finally got around to ordering the part and I installed it tonight. The problem is fixed! Or is it? It came back up after leaving the TV on for a few hours, and then it went away on its own... any other ideas? I'm right at the $$$ amount that a new TV seems like it'll be a better option.

                Comment

                • budm
                  Badcaps Legend
                  • Feb 2010
                  • 40746
                  • USA

                  #9
                  Re: Samsung ln40a530p1fxza (white screen)

                  Did you put the pink thermal pad back on top of that IC?
                  Never stop learning
                  Basic LCD TV and Monitor troubleshooting guides.
                  http://www.badcaps.net/forum/showthr...956#post305956

                  Voltage Regulator (LDO) testing:
                  http://www.badcaps.net/forum/showthr...999#post300999

                  Inverter testing using old CFL:
                  http://www.badcaps.net/forum/showthr...er+testing+cfl

                  Tear down pictures : Hit the ">" Show Albums and stories" on the left side
                  http://s807.photobucket.com/user/budm/library/

                  TV Factory reset codes listing:
                  http://www.badcaps.net/forum/showthread.php?t=24809

                  Comment

                  • Tfsjake
                    Member
                    • Jul 2015
                    • 14
                    • United States

                    #10
                    Re: Samsung ln40a530p1fxza (white screen)

                    Originally posted by budm
                    Did you put the pink thermal pad back on top of that IC?
                    This is the exact part I installed. It was said to have been pulled from a working TV.

                    I guess it's possible that this one is bad too?
                    Attached Files

                    Comment

                    • Tfsjake
                      Member
                      • Jul 2015
                      • 14
                      • United States

                      #11
                      Re: Samsung ln40a530p1fxza (white screen)

                      Bump, any other ideas?

                      Comment

                      • Glitcher
                        Badcaps Veteran
                        • Mar 2013
                        • 673
                        • USa

                        #12
                        Re: Samsung ln40a530p1fxza (white screen)

                        If it came back and went away on its own, I would recheck your soldering and see if theres any lose connections. Reflowing would be a good idea also.

                        Comment

                        • Tfsjake
                          Member
                          • Jul 2015
                          • 14
                          • United States

                          #13
                          Re: Samsung ln40a530p1fxza (white screen)

                          The new-to-me board was installed and ever since then the picture improves for about an hour, and then starts to looking super saturated and then goes to being washed out. For a few minutes it went to looking negative again.

                          Thinking about returning this board and calling it quits with this TV unless anyone else has something I should try.

                          Comment

                          • Tfsjake
                            Member
                            • Jul 2015
                            • 14
                            • United States

                            #14
                            Re: Samsung ln40a530p1fxza (white screen)

                            Originally posted by Glitcher
                            If it came back and went away on its own, I would recheck your soldering and see if theres any lose connections. Reflowing would be a good idea also.
                            I replaced the entire t-con board with a 'new to me' board from eBay that was pulled from a damaged panel TV. My soldering skills are not up to the task of replacing the component.

                            Comment

                            • Glitcher
                              Badcaps Veteran
                              • Mar 2013
                              • 673
                              • USa

                              #15
                              Re: Samsung ln40a530p1fxza (white screen)

                              I would mostly say probably you got a bad tcon from them.

                              Comment

                              • Tfsjake
                                Member
                                • Jul 2015
                                • 14
                                • United States

                                #16
                                Re: Samsung ln40a530p1fxza (white screen)

                                Originally posted by Glitcher
                                I would mostly say probably you got a bad tcon from them.
                                That's good to know. I will return this one, eat the shipping cost, and try one more time. Thank you.

                                Comment

                                • jetadm123
                                  Badcaps Legend
                                  • Feb 2010
                                  • 2169

                                  #17
                                  Re: Samsung ln40a530p1fxza (white screen)

                                  Did you try cleaning the tcon ribbon cables and re-seating them?

                                  Comment

                                  Related Topics

                                  Collapse

                                  • harp
                                    White screen repairs
                                    by harp
                                    To ask here... I have few devices with white screen problem, actualy nokia 2220 and some fuji? camera, and try to understand what is common problem to cause that issue.
                                    Yes, both devices work everything else probably ok, I mean, I hear intro melody and keypress click sound, DTMF tone, power on off... all ok.
                                    On desk is nokia 2220 slide, and I check all screen connectors and components arround it, measure voltage drop, but all looks ok. I suspect on slide flex cable, but it look ok and white screen is not interupt while flexing board, pushing conectors, and sliding up down. In attachment...
                                    05-13-2024, 03:43 AM
                                  • Chrissygizmo
                                    samsung galaxy ao2s very temperamental after screen replaced
                                    by Chrissygizmo
                                    Hi , I've recently replaced the screen in my Samsung galaxy ao2s, at first it wouldn't even turn on, it had the charging symbol on the screen when plugged in but the green circle wasn't going around to show it charging....
                                    Ive eventually managed to get it on and working but it's very temperamental...

                                    The battery icon always reads as 50% , when the phone goes into lock screen mode i sometimes can't get the screen back on unless I plug the charger in to get it to light up, also it keeps putting the camera app on.. u think it could be something to do with the side buttons. ...
                                    05-26-2024, 12:05 AM
                                  • Kiberge
                                    Samsung LH82QENELGC/EN Help needed - Static line on screen
                                    by Kiberge
                                    HI guys!

                                    I've got a Samsung LH82QENELGC/EN with a problem and need some advice and I hope this is the forum to use?
                                    I'm from Norway so I'd like to apology in advance if my description of the fault is kind of simple or the names on the components are way off. 😊

                                    the TV is powering up, working as normally and picture is all good, except a 1.5-inch-wide vertical line of snow/static across the screen.


                                    This TV is a Signage Display/Public Display version and it's been used at my work for 4-5 years showing commercials 24/7. The fault occurred when...
                                    04-22-2024, 11:28 AM
                                  • Ryan.man
                                    Macbook 2017 with touchbar (A1706) won't turn on after removing the screen
                                    by Ryan.man
                                    Hello everybody! Posting this in hopes somebody has some expertise that leads to a clear path of troubleshooting that saves me a lot of time!

                                    My macbook has the flex cable problem, the one that prevents the screen turning on. Ive been dealing with this for the last 3 years. Last year it went dead and I managed to fix it following youtube tutorials. But my fix wasnt the best, the problem returned a month later. This week, it went dead again. I again tried to fix it.

                                    This time the original cable broke too close to the screen, it can't be fixed without tearing the screen...
                                    02-04-2025, 12:23 PM
                                  • EazyBone
                                    Sharp LC-65Q620U White Screen
                                    by EazyBone
                                    Another TV topic!!
                                    I got this sharp TV that when I first plugged it in it showed the sharp logo and then went to the input screen. This was about 30 seconds and then it showed white screen. Now I can't see anything but white screen. This has a separate TCON and Main.

                                    The TCON is getting 12V and several parts are as well but the VGH line is only .5Volts which I thought is totally incorrect.

                                    Am I on the correct assumption that the TCON is bad somehow if I'm only getting that voltage or is there something else I should check?...
                                    08-21-2024, 12:56 PM
                                  • Loading...
                                  • No more items.
                                  Working...