All the contact pins looks ok.
I also turned the LVDS around 180 degrees. So, I connected the end that was on the MB to the T-con and vice versa.
In my thinking, if the fault was in the LVDS or a PIN the fault should have been different, or the line should have moved on the screen because the faulty pin vas moved?
Kiberge
Kiberge
Last Activity: 05-27-2024, 02:40 AM
Joined: 04-21-2024
Location: Grimstad
-
So next logical step would be to search for a second hand main board then?...Leave a comment:
-
Removed these two cables and I've got 12v at this fuse.
Baclight on, but screen's only black, no image....Leave a comment:
-
2- could you remove the heat sink from MB and let see clear high resolution photo to know more about the signal... if there another CPU beside the main Soc
Heat sinks removed from both boards...Leave a comment:
-
1- you can play this test again with one ribbon discommoded a time.
If you mean like this, there's no image showing on screen, only backlights....Leave a comment:
-
Leave a comment:
-
Leave a comment:
-
Leave a comment:
-
Samsung LH82QENELGC/EN Help needed - Static line on screen
HI guys!
I've got a Samsung LH82QENELGC/EN with a problem and need some advice and I hope this is the forum to use?
I'm from Norway so I'd like to apology in advance if my description of the fault is kind of simple or the names on the components are way off. 😊
the TV is powering up, working as normally and picture is all good, except a 1.5-inch-wide vertical line of snow/static across the screen.
This TV is a Signage Display/Public Display version and it's been used at my work for 4-5 years showing commercials 24/7. The fault occurred when... -
Hi this is Knut from Norway.
Just joined this forum for some advice :-)Leave a comment:
No activity results to display
Leave a comment: