Samsung LN46A550 Power Cycling

[budm]

Re: Samsung LN46A550 Power Cycling

https://www.badcaps.net/forum/showpo...&postcount=135

https://www.badcaps.net/forum/showth...t=25810&page=7

[zdsh07p9]

Re: Samsung LN46A550 Power Cycling

So were the ones I ordered from HBElect.com decent for the job?

[Terryfictv]

Re: Samsung LN46A550 Power Cycling

Here is how I mount the new cap

[budm]

Re: Samsung LN46A550 Power Cycling

So were the ones I ordered from HBElect.com decent for the job?

http://www.hbelects.com/index.php?ma...roducts_id=625

I do not see the spec, but if Terryfictv uses it and it works then it should be OK.

[zdsh07p9]

Re: Samsung LN46A550 Power Cycling

Looooooks good! I cant wait to get mine in!

[zdsh07p9]

Re: Samsung LN46A550 Power Cycling

HB had them on backorder, just ordered the ones budm suggested, should be here soon!

[saddle_au]

Re: Samsung LN46A550 Power Cycling

Just a quickie,

If you solder a rb cap to replace an smd, think about a tiny bit of the black foam/rubber type double sided tape between it and the board when you lay the cap down. The tape helps stop it vibrating long term causing a solder failure, helps you solder it it holds the cap in place and provides some more insulation between any pins under the can and the can. Avoid the latex type filler and silicon like they use on the component side to hold large caps, a lot of it goes brown and conductive after a while.

[wang_breeze]

Re: Samsung LN46A550 Power Cycling

Hi zdsh07p9,

Any update?

Thanks,
LW

[zdsh07p9]

Re: Samsung LN46A550 Power Cycling

Had to order a used main board on eBay, those two didn't fix mine. Still had to heat it up for it to turn on...

[wang_breeze]

Re: Samsung LN46A550 Power Cycling

Well, that's dissappointing. Anyhow, congrats on fixing it.

[husky601]

Re: Samsung LN46A550 Power Cycling

zdsh07p9 did you figure what your problem is? I would think you will have to change the Voltage Regulators - Switching Regulators and the Schottky Diodes & Rectifiers.

Parts are available here: http://ca.mouser.com/Search/ProductD...-CD214A-B240LF

http://ca.mouser.com/Search/ProductD...946-MP2363DNLF

Alexis

[widgeonwing]

Re: Samsung LN46A550 Power Cycling

new member, short term reader, I'm working on a samsung 46 lcd for my father in law.
model# ln46a550. I've read about replacing the caps on the power board and will start there. His issues are that when the tv is cold, it has a very loud buzz and green fuzzy pic. It restarts on it's own 4 or 5 times and then all is fine. Something heats up and is great after that. Any help?

[budm]

Re: Samsung LN46A550 Power Cycling

Should inspect the caps on the power supply board first, bad caps can look normal, you will need ESR meter to test them. More likely to be C102 on the main board problem.
http://assets.shopjimmy.com/media/ca...side_2__22.jpg

[widgeonwing]

Re: Samsung LN46A550 Power Cycling

Thanks man.... I'll try my hand at replacing the 102 and go from there. Dave

[buckscrape]

Re: Samsung LN46A550 Power Cycling

What about the EEPROM short 5 & 6, problem is identifying the EEPROM can't seem to locate it on my Samsung LN46A530P1FXZA

[budm]

Re: Samsung LN46A550 Power Cycling

Lest us see the pictures of the bottom side of your main board.
https://www.badcaps.net/forum/showpo...7&postcount=36

[buckscrape]

Re: Samsung LN46A550 Power Cycling

Thank you, Thank you, Thank you

[buckscrape]

Re: Samsung LN46A550 Power Cycling

what is c139 and where do I get one

[budm]

Re: Samsung LN46A550 Power Cycling

what is c139 and where do I get one

Where did you see the c139? on the main board? Does the main board you have has C102?

[buckscrape]

Re: Samsung LN46A550 Power Cycling

Next to C102