Re: olevia lcd tv killed by cockroach
Oh, these wasps were nice and warmed up.
Fortunately the cylinder head landed in nice soft dirt.
Oh, these wasps were nice and warmed up.
Fortunately the cylinder head landed in nice soft dirt.
-
Mann-Made Global Warming.
- We should be more concerned about the Intellectual Climate.
-
Be who you are and say what you feel, because those who mind don't matter and those who matter don't mind.
- Dr Seuss
-
You can teach a man to fish and feed him for life, but if he can't handle sushi you must also teach him to cook.
-
-
Re: olevia lcd tv killed by cockroach
Well if you could go back in time I'm sure you would have removed the spark plug shot some gas in there and cranked the engine a few timesOriginally posted by PCBONEZ
.
Elements of the past and the future combining to make something not quite as good as either.Comment
-
Re: olevia lcd tv killed by cockroach
Don't think so.
It was sitting in a truck bed 'out back' of the barn.
.Mann-Made Global Warming.
- We should be more concerned about the Intellectual Climate.
-
Be who you are and say what you feel, because those who mind don't matter and those who matter don't mind.
- Dr Seuss
-
You can teach a man to fish and feed him for life, but if he can't handle sushi you must also teach him to cook.
-
Comment
-
Re: olevia lcd tv killed by cockroach
Where I am, wasps like to nest in car doors. I had one below the B pillar on the passenger side this summer. It was only a couple of them when I found it but they kept coming back and making a nest again. I had to fight them off with weed spray so i could knock down the nest and drive the car. They then moved to the roof of the garage and I finally broke down and bought raid wasp spray.Comment
-
About 2 times a year, a customer will do this. We fix the tv, put it on test play, and customer sees it working. They see me pull power and video wire. Sometimes I pick up tv, right in front of them, and carry it out to their vehicle while they are next to me. I set it in their tv gently, and tell them the tv is very fragile, be careful with it. I let them close the door/trunk. That day, or a few days later, they tell me there is a crack inside the tv. Normally I tell them transportation is their responsibility and normally that is the end of it. Has anyone had a customer that was not buying this... -
Customer plugged in samsung monitor into the board and used it as a power supply, killed UG800 and UG400. I replaced those two with an exact donor board we had In stock and working, board pulls 5volts and then gets like 2.89 amps on the left side. The singular port is the port that failed. Used a perfectly working chips from donor (board was locked) Now I only get 5volts 0 amps on that power and then 20volts 0 amps on the two left side ports, I checked for DFU and nope nothing, computer not turning on. No shorts present anymore. I am confused as I used the exact components from an identical...
-
Customer plugged in samsung monitor into the board and used it as a power supply, killed UG800 and UG400. I replaced those two with an exact donor board we had In stock and working, board pulls 5volts and then gets like 2.89 amps on the left side. The singular port is the port that failed. Used a perfectly working chips from donor (board was locked) Now I only get 5volts 0 amps on that power and then 20volts 0 amps on the two left side ports, I checked for DFU and nope nothing, computer not turning on. No shorts present anymore. I am confused as I used the exact components from an identical...09-10-2025, 03:15 PM
-
Yes it's a 17 year old Panasonic plasma!
I was watching TV when there was a huge lighting strike nearby my house that shook the house. When that happened, the picture on the TV froze and the TV wouldn't turn off except by pulling the power cable. Now if you plug in the TV, it seems to turn on (it makes the turn on "clikcs" it always does, the red power light comes on but there is no picture, although I can see the back light around the edges. And the TV doesn't respond to the power button on the remote to turn off, and doesn't respond to the manual power button on the front... -
Sublect line continuation: ... Jaguar IDS PC aka Panasonic
>Read BIOS guides, methods, resources and tools
>
Ack
>Try the method at BIOS guides, methods, resources and tools before requesting help
>
Ack
>Explain you were not able to succeed with the methods at BIOS guides, methods, resources and tools
>
python ./main.py "/mnt/c/temp/205605f9e1b60403a41787efeffe9cad-flas_maybe5.BIN" --output-dir "/mnt/c/temp/205605f9e1b60403a41787efeffe9cad-flas_maybe5.txt"
------------------------------------------------...
Comment