The whole discussion started wrong, i suggest to re test all by the begin, some measurements, the pin numbers, and the rest doesn't match, first gather a proper piece of straight wire to be instert in the connector, test all pins, if no volts, the check the main 400v cylinder caps, stay concentrated, a wrong move can make an huge spark, if you have no steady hands, don't try , then search for fuses..
-
-
Bought a new Power board, still got the same issue… seems like it’s the main boardComment
-
If you think you want to buy every part without thinking and no measurements so theres no need to open a thread, it's only a pain to read for a tech..Comment
-
There was also an issue with the power board, it’s a new power board so now it’s just a case of knowing what I can check next in order to possibly fix the tv, still getting no standby light. So let’s start fresh. Power board is 100% working, now I need to know what else to check. No more parts are being bought. Thanks and much appreciatedComment
-
Hi, this is my personal laptop, which the original board (lets call it Board A) blew up PU8700 (TPS51486), making a hole on the board, i had left the laptop at my desk one day with the battery fully charged and didn't touch it for a week, but when i tried to turn it on it didn't
Thought the battery was dead, so i plugged in the charger then tried to power on, the power LED blinked once, charged LED still orange, unplugged the charger, plugged in again and I noticed the "magic smoke" smell, so i unplugged the charger, removed the back cover and saw the blown IC (the "magic... -
Problem
This is an LG edge LED lit LCD Display. The LEDs are on the bottom edge of the display. There are 2 bars (left and right) Each bar has many LEDs and a 6 pin connector. Each pin drive several LEDs thus is the highest current flow / heat junction. The weak lead free solder gradually fails with thermal expansion/contraction cycling and increases resistance. PSU will compensate up to a point, then when the current is too high, PSU just shut down the backlight causing a dark display. I have even seen one which the connector just fell off as solder points became completely detached.... -
Vizio e601i-A3 - Has Sound and Display, But No Backlight - Bad Power Supply Board or Bad LED Bulbs ?I was given this TV from my great uncle. He said it just wouldn't turn on one day out of nowhere, replaced the TV, and gave it to me to possibly fix and use for myself.
Upon bringing it home and plugging it up, it showed a standby light.
I powered it on and without a flashlight, the display showed the "V" but the lighting is very dim, but visible.
The screen seems to blackout and stay black, but with a flashlight I can see the display.
With my Playstation 4 connected via HDMI, and running a game I can hear sound.
Assuming... -
Diagnose (panel problem)
- main board replaced- still no good
- panel board check all supply present and correct voltage
- hang flex ribbon main board to panel (error 5blink) but when connected again nonstop red blink no pose and green light steady
-SDA and SCL supply 3.3v panel board
-BL is good simulated
Guys help me any suggestion
Main board protect 12v shut off when connected to panel board -
All left and right refers to looking from rear of TV (or looking from front with TV upside down)
- TV came with vertical bars and no image. Found faulty TVS on left buffer board. Also replaced T-Con (may have damaged the original while hot air removing components, board has slight warp) and have full image but few horizontal lines on the screen. Some of the lines appears to be 2 pixel tall while others are 1 pixel tall.
- Disconnecting left and right buffer board potentially reveals problems on both sides with different signals (unless this T-Con require jumper like Samsung FB_TRDY1&3) Fault
Comment