Thanks guys for those suggestions.
I did check the resistance across the buttons when they were pressed/not pressed. They all seemed to be working fine. When pressed they were like 0.2 ohms and 1mega ohms when not pressed. I see what Lotas posted above in post #16. I can look at those again.
The "AutoVolume" is set to OFF in the settings.
I have attached a pic of the board below. Yes, it appears to be similar to the one Lotas posted in post #9 above.
I have tried to do an update, but it says I am up-to-date. I watched the YT video on the key sequence for the factory reset (vol down+Input). Will give that a shot tomorrow.
I did check the resistance across the buttons when they were pressed/not pressed. They all seemed to be working fine. When pressed they were like 0.2 ohms and 1mega ohms when not pressed. I see what Lotas posted above in post #16. I can look at those again.
The "AutoVolume" is set to OFF in the settings.
I have attached a pic of the board below. Yes, it appears to be similar to the one Lotas posted in post #9 above.
I have tried to do an update, but it says I am up-to-date. I watched the YT video on the key sequence for the factory reset (vol down+Input). Will give that a shot tomorrow.
Attached Files
Comment