-
Last edited by tw2005; 07-14-2014, 07:06 AM. -
Re: Panasonic TH-P50VT20A vertical line
I was hoping the parts may be interchangeable incase i could swap some bits around ... but totally different i beleive
all good , i will just have to put up with the line for a while and having the projector sitting on the coffee table when the line starts to annoy me or watching a movie..Comment
-
Re: Panasonic TH-P50VT20A vertical line
Definitely VT10, not V10? A G10 with a good panel could be a better thing to look out for if you really wanted to salvage a plasma with the old boards. You'd have to check what SC yours has or PZ80/800 series with 2 or 10 blink which can commonly be a simple cap replacement on the PSU.
A V20 with 4 or 10 blink can be common Sc board short.
Don't see a lot of good stuff on ebay now.Comment
-
Re: Panasonic TH-P50VT20A vertical line
Not exactly close to brisbane but this sounds like it will be infamous PSU issue.
http://www.ebay.com.au/itm/Panasonic...item35d9186a8f
This one, could be as simple as a poorly seated LVDS lead or dirty connector. May also end up with a PSU fault if it has not already had a fix.
http://www.ebay.com.au/itm/Panasonic...item4623405249
This one, most likely failed SC board and or buffers. Can be component repaired if able to do that sort of work.
http://www.ebay.com.au/itm/PANASONIC...item43cbfb633fLast edited by tw2005; 07-14-2014, 07:23 AM.Comment
-
Re: Panasonic TH-P50VT20A vertical line
you are correct, it is a P50V10A not a P50VT10A
I will keep an eye out for another g10 or v20 with a good panel in the mean time tho..
i am hooked on the plasmas, you cant go past the deep blacks...
Comment
-
Re: Panasonic TH-P50VT20A vertical line
V20 , if you score might be able to help out if it's just the SC required. The SC in the VT20 is a different version due to 3D.Comment
-
Re: Panasonic TH-P50VT20A vertical line
that last one is also on gumtree... and cheaper than the current bid
http://www.gumtree.com.au/s-ad/maroo...-tv/1050956006Comment
-
Re: Panasonic TH-P50VT20A vertical line
You'd have to quiz them and see if there is a blink code. A dead short can also cause a solid LED , no blinks. Not sure how reliable that model is long term. My experience stops at the 2010 models.
Should be a few posts though for 2011 models with failed SC or buffers.Comment
-
Hi all, I tried searching the site for answers but I'm a bit over my head understanding some of what might apply and what doesn't, so please be patient with me. I used Freakaftr8's fix to remove the left driver board to restore picture to a black screen with sound Vizio E701i-A3. After doing so, I now have a large red vertical stripe down the center of the screen. The fix did require getting another t-con board from online, I ordered it before I knew about the mosfit fix for the old t-con board. I have tried cleaning the cable connections to the t-con board. I swapped the cables going from...08-19-2025, 06:11 PM -
Hi all.
I have a Kogan 65' LCD Panel with a thin blue vertical line (top to bottom) on left hand side of panel.
The line just happens to coincide with the end of COF and start of the next COF (attached).
The line is permanent no matter what I've tried. I've tried pressure testing the panel (top to bottom) and all over, I didn't notice any difference with the line, either temporary or semi-permanent.
Also tried unplugging all flex cables, cleaned with isopropyl then re-inserting to no avail - line remains.
Hoping to fix... -
Failure Symptom
No picture, just red vertical stripes. Google search shows quite common problem for these recent Vizio M series although red vertical stripe pattern may differ. Some call it "Netflix" boot screen haha.
Where is the short?
Panel has 4x buffer boards. Quickly found the 1/4 panel buffer board with the problem by selectively disconnecting buffer board flex cables.
Having recently fixed another Vizio with similar symptoms that was a shorted ESD diode array ( link ) Probed the ESD diode array but... -
Has one here really gone through fixing laptop screen vertical line(s) by repairing/replacing its Embedded DisplayPort (EDP) cable, so would recount and share the complete steps of the process here now?
As most, if not all, believe the laptop screen vertical line(s) caused by defective Embedded DisplayPort (EDP) cable which slipped and passed through either laptop screen hinge but post here is asking help to elaborate definitively the useful, real knowledge of repairing in the most complete, correct way, esp. can decide/determine whether the cable can still be fixed or must be re... -
Hello all ~
Hope this finds you well. This LG 82UN8570AUD (April 2021 model) 4K UHD television has full audio capabilities but video is compromised / problematic.
When I picked up this large LG tv it had a full black screen upon startup. Previous owner said it just went black one day. No popping sound or anything else of note.
I got the display to work by taping off several traces of the right-hand side ribbon cable on the TCON that leads from TCON to PANEL. However, despite dozens and dozens of attempts to find the right combination / range of traces taped...
Comment