Sony LED 65X9005A shuts down after few seconds - looking for help

[lotas]

Decide with these resistors for now.

[lotas]

[ Numbers on the 4 boards match: https://www.taobao.com/list/item/545233842385.htm

Yes, these are the ones.

[tec3000]

lotas thank you for the help! Taking the pics took too much time today. Tomorrow I will try to check the resistances. I have also found the exact boards at this site - unknown to me. You or Diah know about it? Numbers on the 4 boards match: https://www.taobao.com/list/item/545233842385.htm

[tec3000]

and board 4:

[tec3000]

board 3:

[tec3000]

board 2:

[tec3000]

this is board 1:

[tec3000]

don't use the mobile camera in flash light mode... just use external light like ( torch ) on the area

I have retaken the pictures. I will upload them now.

[tec3000]

yours photo , here could be parts falling down too

Ah! I forgot to tell you about it. I was able to identify the mysterious "L" on the left bottom of the TV. Luckily I didn't even have to disassemble anything. One problem less!

[Diah]

yours photo , here could be parts falling down too

[lotas]

And then check RH4, it’s hard to see.

[lotas]

Check R2, it should also show a short circuit (0 Ohm).

[lotas]

you mean R007.. i don't think its in use,.... OP you need to shoot very clear photo on the area close to the IC

R007 is torn off and hanging on one side, if it is alive (has a short circuit), then just solder it on both sides.

[tec3000]

don't use the mobile camera in flash light mode... just use external light like ( torch ) on the area

Ok, will do! Thank you for the suggestion.

[Diah]

OK, I think it's best to shoot during daylight. It's extremely hard to get good pics right now. I will do ASAP.

don't use the mobile camera in flash light mode... just use external light like ( torch ) on the area

[tec3000]

you mean R007.. i don't think its in use,.... OP you need to shoot very clear photo on the area close to the IC

OK, I think it's best to shoot during daylight. It's extremely hard to get good pics right now. I will do ASAP.

[Diah]

Everything I saw, the most important thing is not the capacitors, here you need to solder a zero resistor or put a jumper on the chip.

you mean R007.. i don't think its in use,.... OP you need to shoot very clear photo on the area close to the IC

[tec3000]

Everything I saw, the most important thing is not the capacitors, here you need to solder a zero resistor or put a jumper on the chip.

Thank you lotas I appreciate you took time to inspect the bars and marked them.

So, just to check... You say "solder a zero resistor or put a jumper on the chip". Does that mean I DO NOT need to solder back the parts that fell off?? Instead I have to buy some resistors and solder them on each bar? And you say OR jumper? So is that an option I have? I have zero experience with these things...

I retook pics of the second board. I can also retake better pics of the other board if you like.

[lotas]

It's hard to see on this bar...

[lotas]

Everything I saw, the most important thing is not the capacitors, here you need to solder a zero resistor or put a jumper on the chip.