Vizio, E60u-D3, no standby light, no ps_on

[p-top]

Have vizio E60u-D3. No standby light. Have searched and read all D??u-D3 posts. posts with same symtoms fixed by new power supply, one guy needed back lights also.
main boards are kinda spendy and, out of stock alot of places. i would like to fix my board.

PS voltages

1 VSNS -2mV
2-5 LED-OUT -2mV
6-10 GND -2mV
11 +16VS 16.29V
12 AC-DET 3.929V
13PS-ON -3mV
14 +16VS 16.29V
15 +16VS 16.29V

[nomoresonys]

It's no wonder you didn't find anything in the search, it doesn't work for shit since they changed up the gui on this site, might want to fix that. Looks like there's a lot less posting going on too.

[p-top]

Just annoyed by it posting before I was done and, it logging me out and loosing a bunch of time typing. I will update as I figure out how to use forum. sorry.

[p-top]

You can see impression of components in this two sided tape. Not sure if that would cause a heat issue for them.
someone said follow the power in on main board to see if it gets to main chip. Not sure how to go about that. Also seen someone comment that vizio has problems with voltage converters or regulators. Assuming the 16 to 5 volts needed for ps-on. Willing to learn have tools and access to more. Looking for some direction from more experienced persons. Thank you, great site and, people!

[nomoresonys]

Just annoyed by it posting before I was done and, it logging me out and loosing a bunch of time typing. I will update as I figure out how to use forum. sorry.

No it's not your fault, whoever made-over this site and how it works, screwed it up.