Announcement

Collapse
No announcement yet.

Baird x32dtv

Collapse
X
Collapse
 
  • Page of 3
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 3 template Next
    #41
    Re: Baird x32dtv

    They do yes 4 pin connector

    Comment

      #42
      Re: Baird x32dtv

      They do yes

      Comment

        #43
        Re: Baird x32dtv

        give a while will take the back off my set i cant remember lol

        Comment

          #44
          Re: Baird x32dtv

          right they go to 12 volt on connector 4 2 lives on 12v the other 2 on gnd thin red wire goes to pin five counting from bottom of connector 4

          Comment

            #45
            Re: Baird x32dtv

            So there are 5 12v altogether did u put 2 on 1 and 30 on the other?

            Comment

              #46
              Re: Baird x32dtv

              sure did works ok i did use heat shrink tube after soldering wires on slide tube right down then heat the heat shrink tube worked great on this set

              Comment

                #47
                Re: Baird x32dtv

                did you manage to sort the psu gazza544

                Comment

                  #48
                  Re: Baird x32dtv

                  Since it seems to be a more hassle than anything to repair this PSU.. and looks like there are lots of this psu have issue. I founded a chinese company have a better designed psu (well at least according to them)..

                  http://www.aliexpress.com/item/The-B...306314414.html

                  Comment

                    #49
                    Re: Baird x32dtv

                    yes i saw something like that when i was looking for one if i remember the psu i used was about £11.50 second hand but gauranteed the set is still working fine with the psu i put in i use it as a bedroom tv.

                    Comment

                      #50
                      Re: Baird x32dtv

                      Hi guys,
                      I have PHIHONG MODEL PSM210-417A-R powersupply now for fix with Wharfedale LCD set and somebody totally destroyed pcb around 5V stby area when tried to repair it before I got TV.
                      Would by anyone able to provide picture of bottom side of the pcb please?
                      On my board traces around IC 301 were damaged see attached picture and as there is no schematics I am not shure how everything is connected.
                      One smt resistor marked in picture has 0 Ohm and can't see value so please help identify if possible.
                      C307,C308 and C311 was also replaced and need those just confirm for value as well.I have now installed C307-470uF 25V , C308 and C311-470uF 16V on front side of the board.
                      Your help would be much appreciated guys.
                      Thanks for any answer

                      Regards Ronan
                      Attached Files

                      Comment

                      Previous 1 2 3 template Next
                      Working...