-
-
Re: LG 42PT350R clicking on/off
Hi Tw2005,
thanks for the info, appreciate that.
currenty my Z-sus loss the vs. replaced RD2004 Commonly transistor, 30F124 and ic driver FAN73711. now get back power....Comment
-
Re: LG 42PT350R clicking on/off
Hi guys,
Currently facing same problem with my LG. Does the VA and VS should always show the voltage? When I connect anything (like Z-SUS, Y-SUS, main board) the VS and VA drops off under 1 volt. I have checked ALL capacitors and all of them are fine. the fuses are good. What that could be?
Thanks in advance and sorry for opening the thread all over again.Attached FilesComment
-
-
Re: LG 42PT350R clicking on/off
hello sir i have problem but i dont no what can i do my 42pt350r LG PLASMA 42 noisy grainy picture plz tell me
my email address
arcomputersmultan@gmail.comComment
-
Hi,
First post...
I have this TV, which was working, then suddenly would not turn on. It would get the clicking relay then flash up the screen for less than a second, off for a second then on again. Removing the plug the relay continues to click on and off for a few cycles, which I don't think it did before.
Left it a few months, then finally got round to taking the back off, and it worked as it should. So I tested various bits and all was well. Then turned it on again, and back to the clicking relay.
I disconnected the main board from the power... -
Hi all!!
Ok just got a Onkyo SKW-593 sub woofer that has no power person told me that it smoked and that his GF let the volume full when she powered off the amp and when he came to turn it on the sub played but then suddenly smoke was coming out, didn't say from where. So opened it up and saw a resistor made of metal (pic) but can't see any writing on metal par so what ever was written on it was burnt. So I'm kinda stuck here with this. I did ask for a repair or schematics in the other group section and waiting for this but I hope someone here might lend me a hand to try and identify... -
Did some of the usual troubleshooting.
Unplug main board connector and back lights come on and stay on and PSU supplies all correct voltages on the legend.
When you just plug in the TV the PSU relay clicks on and off immediately and then continues to click on and off every 20 seconds or so. The red light on the front flashes once and then 5 to 8 seconds later flashes once again and continues the cycle with the relay.
I've disconnected each you ribbon cable one at a time and every single T-Con cable one at a time to see if there's any change. No change as long... -
Hi,
I have this OLED in standby. With remote or local button it tries to start, relay clicks but switches off again immediately. I have noticed 24V dc out missing . But this was due to a missing signal from the mainboard at DRV-ON signal. If I apply 3.5 volts 24v is on but same result. Have disconnected TCON cables one by one but still same issue.
Is there any mainboard reset procedure or testing please as am new to this model.
Tks!... -
Hello, I bought this Mac from a friend, he said that it simply stop working. The MacBook looks very clean but does not power on, stuck on 5v 0.42A, and sometimes display 5V and 0A (then 0.071A and again 0A).
I opened it looking for some problem, it was not touched before for sure and the board is very clena, no spot of corrosion at all from what I can see. Voltage on multimeter of the board off the case it's the same, 5V 0.42A. But then I noticed this "clicking sound" come from the board ( I attached here the audio file).
Looking on google I found this:...
Comment