Replaced T-con board and now getting vertical lines

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • sr9800
    replied
    Re: Replaced T-con board and now getting vertical lines

    yes, it is correct ...

    do you think i got a faulty t-con board ?

    or is it possible that the tv has a faulty panel or main board ?

    Leave a comment:


  • budm
    replied
    Re: Replaced T-con board and now getting vertical lines

    Did you match the P/N on the barcode, not as printed on the board.

    Leave a comment:


  • sr9800
    replied
    Re: Replaced T-con board and now getting vertical lines

    Yes, the same exact t-con...

    i am sure...

    Leave a comment:


  • tom66
    replied
    Re: Replaced T-con board and now getting vertical lines

    Was the T-con an exact match?

    Leave a comment:


  • sr9800
    started a topic Replaced T-con board and now getting vertical lines

    Replaced T-con board and now getting vertical lines

    I have a Sony bravia KDL46VL160, first problem was a blank screen with sound.

    When bought and replaced the t-con board, coloured vertical lines are as shown in the picture

    What do you all think is the problem ?

    Thanks for the help...

Related Topics

Collapse

  • Stanley1843
    Screen Display Vertical Multicolor Lines
    by Stanley1843
    Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesn’t display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed...
    06-29-2024, 11:54 AM
  • Daren87
    Sony 8K XBR-75Z8H White Screen Vertical Bars Tcon Code. Help Needed🙏
    by Daren87
    Hello everyone,

    I've recently been given a Sony 8k Z8H. It's got a white screen with two vertical black bars. At times it's given me the 5 blink Tcon code. Testing voltage on the Tcon I can see some low or missing voltage. I've done a basic visual check of cables and the COF. Not seeing anything obvious. The original Tcon seemed to have good caps until turning it over. On the bottom I found maybe 10 caps with both sides of the caps shorting to ground. I thought ok these caps and likely other components on the Tcon are shorted so let's try a replacement Tcon. I just received the...
    08-13-2023, 03:25 PM
  • Falki
    Colorful LCD Vertical Lines on Samsung ue55es8090
    by Falki
    Hello there, ive recently found an older 55inch Samsung SmartTV.
    Sadly it has vertical lines at the left and one line in the middle-right.

    I have already tested out the connections and have looked at the soldered ribbons of the LCD panel to see if some contacts got loose by pushing them a bit but with no success.
    I have factory resetted the TV as well but also with no luck.

    I am afraid that it is indeed a LCD Panel issue but there are NO scratches or any impact-marks..

    A similar issue has been posted as well but also with no actual response ...
    08-12-2025, 04:19 AM
  • gpo23
    Sony KDL-40V3000 - Vertical lines
    by gpo23
    Hello,

    i order a t-con because i had bad colors on my SONY KDL-40V3000 :




    With the new t-con the color are good but there are vertical lines on all the screen :




    I've tried the old t-con and it returned to the initial issue (bad colors but no vertical lines)

    Is there a way to fix the vertical lines on the new t-con ?

    Thank you for your help

    gpo23...
    10-04-2023, 09:11 AM
  • x_orange90_x
    TCL 50S535 bad tcon or panel issue?
    by x_orange90_x
    Just bought this for 10 bucks yesterday hoping to fix it. The guy said water dropped inside from a dehumidifier hose and it started showing black and white vertical bars then went blank. When I got it home and turned it on it came on fine and displayed correctly but I was noticing faint vertical bars in the image. After a little bit I turned it off and back on and it was a black screen again. I opened it up to check for water damage and corrosion but didn't find anything of the sort. I cleaned the ribbons anyway and reconnected them but still got a blank screen. If I disconnect the right side...
    03-29-2025, 11:02 PM
  • Loading...
  • No more items.
Working...