Re: Replaced T-con board and now getting vertical lines
havent played with bond tabs yet, n scared to try eveN!
Replaced T-con board and now getting vertical lines
Collapse
X
-
Re: Replaced T-con board and now getting vertical lines
have checked the voltage on TCON, its good!
idk what could be the fault ? :/Leave a comment:
-
-
Re: Replaced T-con board and now getting vertical lines
Any one of the whole chassis?Leave a comment:
-
-
Re: Replaced T-con board and now getting vertical lines
will post tommorow! the whole of TV!
Thanks TOM66 for so much help! and BadCaps too!Leave a comment:
-
-
Re: Replaced T-con board and now getting vertical lines
What about one of the rest of the TV?Leave a comment:
-
Re: Replaced T-con board and now getting vertical lines
thanks again!
this is the picture of old TCON! LINKhttp://db.tt/RJGiVua1
Leave a comment:
-
Re: Replaced T-con board and now getting vertical lines
Usually the tab bond faults get worse progressively, but there have been reports of sudden failures due to tab bonds. I recommend you try and eliminate it. Also, can you post pictures of inside your TV? Perhaps there is another board that can cause this. Unlikely, though.Leave a comment:
-
Re: Replaced T-con board and now getting vertical lines
Yes, it is quite possible you have a bad tab bond.
Different fault, same possible cause + possible fix:
https://www.youtube.com/watch?v=purk_SyiT44
so the summary is it was working perfect and running smooth and next moment it was at fault!
what could be the culprit?
Last edited by shanusmarty; 06-14-2013, 03:00 PM.Leave a comment:
-
Re: Replaced T-con board and now getting vertical lines
Yes, it is quite possible you have a bad tab bond.
Different fault, same possible cause + possible fix:
https://www.youtube.com/watch?v=purk_SyiT44Leave a comment:
-
-
Re: Replaced T-con board and now getting vertical lines
You may have a main board or panel fault then.Leave a comment:
-
Re: Replaced T-con board and now getting vertical lines
i originally had vertical lines with audio, but same results after replacing TCON!
Please help!
this was the original condition with out replacing TCON!
http://www.youtube.com/watch?v=PKrUvpyHxUILast edited by shanusmarty; 06-14-2013, 02:32 PM.Leave a comment:
-
Leave a comment:
-
-
Re: Replaced T-con board and now getting vertical lines
even i have the same problem, but i replaced TCON, but no solutionsLeave a comment:
-
Re: Replaced T-con board and now getting vertical lines
I would suspect the T-con in this case.Leave a comment:
Related Topics
Collapse
-
by Stanley1843Hello, I have a screen in where sometimes when I open it pop-up vertical multicolor lines (I would say the most of them are green). If I tun off and turn on the screen the lines dissapear or if I leave open the screen after approximately five minutes the lines gone. I measured the below voltages on the main PCB and on the T-CON board and the voltages are the same when it doesnโt display the vertical lines and when it displays the vertical lines. Also, I cleaned all the connectors very good with IPA. I moved back and forth the connectors and the COF tabs but the vertical lines didn't displayed...
-
Channel: Troubleshooting Computer Displays
-
-
by Daren87Hello everyone,
I've recently been given a Sony 8k Z8H. It's got a white screen with two vertical black bars. At times it's given me the 5 blink Tcon code. Testing voltage on the Tcon I can see some low or missing voltage. I've done a basic visual check of cables and the COF. Not seeing anything obvious. The original Tcon seemed to have good caps until turning it over. On the bottom I found maybe 10 caps with both sides of the caps shorting to ground. I thought ok these caps and likely other components on the Tcon are shorted so let's try a replacement Tcon. I just received the... -
by gpo23Hello,
i order a t-con because i had bad colors on my SONY KDL-40V3000 :
With the new t-con the color are good but there are vertical lines on all the screen :
I've tried the old t-con and it returned to the initial issue (bad colors but no vertical lines)
Is there a way to fix the vertical lines on the new t-con ?
Thank you for your help
gpo23... -
by x_orange90_xJust bought this for 10 bucks yesterday hoping to fix it. The guy said water dropped inside from a dehumidifier hose and it started showing black and white vertical bars then went blank. When I got it home and turned it on it came on fine and displayed correctly but I was noticing faint vertical bars in the image. After a little bit I turned it off and back on and it was a black screen again. I opened it up to check for water damage and corrosion but didn't find anything of the sort. I cleaned the ribbons anyway and reconnected them but still got a blank screen. If I disconnect the right side...
-
by HakuuHi There,
This TV was auto switching off after few seconds with some vertical lines on the screen, so got a new TCON board and replaced it.
After replacing the TCON board it was working fine and i set it up with everything, used for few hours, then had the bright idea to update the software on it. During the update process, TV switched off and now no audio or video. No relay switch sound.
More Details
TV Model - LG OLED77G1PUA
Got the same exact TCON board from TVPartsToday and replaced it. But didnt transfer the EPPROM data (didnt... - Loading...
- No more items.
Leave a comment: