Announcement

Collapse
No announcement yet.

Replacing a Lucius & Baer CC14 monitor

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Replacing a Lucius & Baer CC14 monitor

    Hi, we are looking to replace a Lucius & Baer CC14 monitor from an early 1990s Wire erosion machine with an lcd monitor. The connector seems to be a 9 pin that is not standard. Does anyone have the pinout information for this model or any information that would help. Thanks.

    #2
    Re: Replacing a Lucius & Baer CC14 monitor

    Hi - I dont believe this - I read your post and as I have no idea what you are talking about
    thought I would google the words. I see you can buy upgrades which look expensive?
    Anyway got bored with it , as I still dont understand what a wire erosion machine is and went back to the forum and found this was posted within 2 posts of yours!! WoW!!!

    https://www.badcaps.net/forum/showthread.php?t=12223

    It may help and I will use that to google further on the pin out side - may be an old
    vga standard I can find or a cga? standard
    Please upload pictures using attachment function when ask for help on the repair
    http://www.badcaps.net/forum/showthread.php?t=39740

    Comment


      #3
      Re: Replacing a Lucius & Baer CC14 monitor

      I think this gives the pin out for the 9 pin
      http://www.ambery.com/db9todbadca.html
      BUT note the warning all 9 to 15 pin connectors are not the same and I believe you will need some form of signal converter
      to change the scan rate.
      HOWEVER this may be of interest
      http://www.microvitec.co.uk/low-scan-monitors.html
      Last edited by selldoor; 04-19-2012, 03:13 PM.
      Please upload pictures using attachment function when ask for help on the repair
      http://www.badcaps.net/forum/showthread.php?t=39740

      Comment

      Working...
      X