hello i got 2 42 inch vimax plasma TV on of them the power supply board whas cracked and i fixed all broken traces the other is powering on but no display can i do a selft test on the panel or what parts i can swap from the workinh unit to know if the panel itseft is good before i do anything else ?
-
-
Re: how do test if a PDP is good ?
Twitter is a useful tool. It forces those with nothing useful to say to demonstrate that in 137 characters or less. We don't have that limitation here.
I read your post three times before I finally figured out what you were trying to ask. An intelligent use of the shift key, and of punctuation would help considerably.
You can swap any boards which have the same board number between sets. I'm not sure who made your TVs; most hits from Googling Vimax refer to a herbal 'male enhancement' product.
PlainBillFor a number of reasons, both health and personal, I will no longer be active on this board. Any PMs asking for assistance will be ignored.
Never be afraid to try something new. Remember, amateurs built the ark. Professionals built the Titanic. -
Re: how do test if a PDP is good ?
Sorry, i will re write my initial post.. The tv is all made by samsung apart from the i/o board.Comment
-
Re: how do test if a PDP is good ?
Good to know. That is a common configuration.
Notice that the power supply must be readjusted for the panel - voltages are on a label on the panel. When testing move the Y-sustain and Y-buffers as a unit from one panel to the other; a bad Y-buffer can blow the Y-sustain.
PlainBillFor a number of reasons, both health and personal, I will no longer be active on this board. Any PMs asking for assistance will be ignored.
Never be afraid to try something new. Remember, amateurs built the ark. Professionals built the Titanic.Comment
-
Re: how do test if a PDP is good ?
I got it working but the is a line in it the panel must be dead i swapped everything!Comment
Comment