Hisense 50A6G
Good afternoon, I have a Hisense 50A6G TV and it has the following defect: "When you enter the Menu by clicking the down arrow button it always returns to the top, as if the up arrow button was being pressed". I already changed the sensor but it didn't solve the problem. Has anyone already encountered this defect or could anyone help me?
-
-
Re: Hisense 50A6G
Hi Elmano ... With tv plugged in ... if there is a small rest button hole on the back. Did you try pushing it and holding it in with a paperclip or something for about 10 seconds and release. Maybe that will reset the glitch. -
Re: Hisense 50A6G
Did or are you trying it with the buttons on the tv instead of the remote if it does have buttons?Comment
-
Re: Hisense 50A6G
I'm using remoteComment
-
Re: Hisense 50A6G
Button may be stuck on the remote. Try what Sony says first if it has physical buttons on tv. It's probably remotes problem. Should also try techs reset also. Reset hole should be by HDMI plugs or around thatComment
-
Does anybody have schematic power board RSAG7.820.9713 from HISENSE TV Hisense 55E76GQ ?? -
85” Hisense TV
Greetings,
Request for Technical Assessment – Faulty Hisense 85Q6NAU TV
Dear TV technicians of forum, I hope this message finds you well.
I am writing to seek assistance regarding my 85-inch Hisense Smart TV, model 85Q6NAU, which is currently experiencing a fault. The unit is approximately two years old, and I am not sure if it has a warranty.
I have attached a photo showing the issue for your reference. I would appreciate it if your experienced technician could kindly review the image and provide some insight... -
Hey folks,
I'm not a professional, but I do have a decent amount of knowledge when it comes to electronic repairs.
A friend of mine recently bought a brand new Hisense 75” 4K QLED Smart TV (75E7NQTUK) but unfortunately, he cracked the screen just a few days later. Luckily, he had insurance and got a replacement right away but weirdly enough, the insurance company never asked for the broken unit back.
So, I took it off his hands and figured I'd try to repair it myself rather than see it go to waste. I've been searching for a replacement screen but can't... -
Hello,
I accidentally changed the project ID in the service menu of my Vidaa Hisense 100U7KQ TV. When I turn on the TV, the screen displays an RGB color cycle (test mode???). I contacted Hisense, and they sent me a usb_MTK_9618.EU.bin file, but it doesn't work. I can see that the USB drive is being read, and it flashes for about 10 minutes (the screen remains in the color cycle during the firmware reading), then the TV turns off and restarts, but still in the color cycle mode.
I want to mention that the 4GB USB is formatted in FAT32 MBR. I've also renamed the file to... -
So I have this Hisense tv where the backlight does not come on. But when it is turned on, when I shine a flashlight on the screen, I can clearly see the splash screen then it turns off. I looked at the mainboard and was expecting to see bulged capacitors, but they all look fine. I unplugged the backlight from the mainboard, and get the same symptoms (i.e. no backlight, dark splash screen then just a black screen). Is this just a backlight issues? Do Hisense tvs turn off by itself if the backlights are unplugged or are bad? Or is this a mainboard issue?
TIA.
Comment