MSI GS75 THIN - MS-17G31 Schematic/boardview

[ethics]

Looking for MSI GS75 THIN - MS-17G31 Schematic/boardview.

Thank you kindly!

[ethics]

bump

[mon2]

Unable to locate a schematic or BV file for this model in my database.

What is the fault? Perhaps it can be diagnosed without the schematic.

[ethics]

I buggered the bios chip pins 1--3-> traces gone and missing resistors =(
Board has major damage.

Thank you for any help you can provide.

[mon2]

Post a few pics of the board shape. Perhaps another model will be similar to allow us to study the schematic.

Also - is it the main bios or another that is butchered?

[ethics]

Main Bios
thus far ms gs75 stealth 9 series seems similar....

[ethics]

Similar to ms-17g11 schematic-Same EC chip
I am going to jump wires from EC chip to resistors-->Bios chip pins 1/2/3....
Any idea what resistors values I should use for pin 1/2/3? would cs# = 1k? 33ohm? cs0? wp#?
I see various values online....

Thank you.

[ethics]

Can someone please upload a photo of Msi gs75 stealth 10sfs motherboard or similar?
the main bios and its resistor values would save my life!

Thank you

[ethics]

bump....

thank you

[Dcortest]

I have a 17G3 Msi laptop, if you still need the photo I can upload it with the values that you need

[ethics]

Please!!!
near the bios chip is buggered
pins 1-4 not sure where vias go also not sure of values of resistors connected to bios pins.

thank you!!!

[Dcortest]

Pin 1 resistor 1kohms
Pin 2 resistor 22.2ohms
Pin 3 resistor 1kohms
Pin 4 resistor 22.2 ohms

The resistor near pin 1 is 100kohms

[ethics]

Thank you so much!!!! any idea the voltages if any of those small vias near pin1-4....? Mine are gone =(

[ethics]

basically I need to know which resistors need +3vsus? I am trying to grab cs0 and spi output from SUPERi/o chip for pins 1/2, pin 3 is write protect and pin 4 should be GND.

[Dcortest]

EC

[ethics]

Looks like Japanese to me

[ethics]

Thank you!

[ethics]

I tried to mark up photo with where I think needs to connect...but can you please assist?
If you could tell me which points need to connect to where?
This is where I am confused...

Thank you.

[ethics]

bump no idea where to start to get this borked board powered up again...
thanks in advance

[ethics]

Anyone in Canada looking for a challenge?
lol...