ethics
Member
Last Activity: 04-18-2025, 06:12 PM
Joined: 10-13-2016
Location: Hamilton
-
Thank you -
try this...Leave a comment:
-
Anyone in Canada looking for a challenge?
lol...Leave a comment:
-
bump no idea where to start to get this borked board powered up again...
thanks in advanceLeave a comment:
-
Thank you!!
Saved my but!
CheersLeave a comment:
-
I tried to mark up photo with where I think needs to connect...but can you please assist?
If you could tell me which points need to connect to where?
This is where I am confused...
Thank you....Leave a comment:
-
Thank you!Leave a comment:
-
Looks like Japanese to meLeave a comment:
-
basically I need to know which resistors need +3vsus? I am trying to grab cs0 and spi output from SUPERi/o chip for pins 1/2, pin 3 is write protect and pin 4 should be GND.Leave a comment:
-
Thank you so much!!!! any idea the voltages if any of those small vias near pin1-4....? Mine are gone =(...Leave a comment:
-
Please!!!
near the bios chip is buggered
pins 1-4 not sure where vias go also not sure of values of resistors connected to bios pins.
thank you!!!Leave a comment:
-
looking for ms-17g31 but this may help!
Thank you!!!Leave a comment:
-
Please any MSI GS75 schematics or boardviews!
Thank youLeave a comment:
-
bump....
thank youLeave a comment:
-
Can someone please upload a photo of Msi gs75 stealth 10sfs motherboard or similar?
the main bios and its resistor values would save my life!
Thank youLeave a comment:
-
Similar to ms-17g11 schematic-Same EC chip
I am going to jump wires from EC chip to resistors-->Bios chip pins 1/2/3....
Any idea what resistors values I should use for pin 1/2/3? would cs# = 1k? 33ohm? cs0? wp#?
I see various values online....
Thank you.Leave a comment:
-
Main Bios
thus far ms gs75 stealth 9 series seems similar.......Leave a comment:
-
I buggered the bios chip pins 1--3-> traces gone and missing resistors =(
Board has major damage.
Thank you for any help you can provide.Leave a comment:
-
bumpLeave a comment:
No activity results to display
Leave a comment: