Lenovo Thinkpad T480 BIOS and EEPROM request

[Xargon1975]

Hi, I've been trying to unlock my T480's BIOS for over two weeks now.
I followed all the instructions, tried AutoPatcher and other BIOS versions, but no luck.
I found out that if the CRC check is wrong, the laptop plays a beep and shows a black screen. I fixed that issue, but now I'm stuck at a stage where the laptop just shuts down.
If I restore the original BIOS, it asks for the password again and stays locked. What can I do???

Type: 20L6-SDR213
Serial No: PF-14H8HB
Bios N24ET77W (1.52 )

[hoaca388]

Hi, I've been trying to unlock my T480's BIOS for over two weeks now.
I followed all the instructions, tried AutoPatcher and other BIOS versions, but no luck.
I found out that if the CRC check is wrong, the laptop plays a beep and shows a black screen. I fixed that issue, but now I'm stuck at a stage where the laptop just shuts down.
If I restore the original BIOS, it asks for the password again and stays locked. What can I do???

Type: 20L6-SDR213
Serial No: PF-14H8HB
Bios N24ET77W (1.52 )

Try agian with AutoPatcher.

[Xargon1975]

Try agian with AutoPatcher.

Thank you for your response and for your assistance.
I attempted to patch the file you provided, but the issue persists.
The system plays the startup melody followed by a blank screen (no display output).
When I revert to the original file you shared, the device boots successfully, but the BIOS remains locked.

[khrapr]

Please need help to remove supervisor password, I've been tried run Lenovo auto patcher and its doesn't work, after power on my laptop "sings" or melody after few second and no picture.
Type T480 20L5-20L6
S/N PF1GR4NL
Bios Version : N24ET79W 1.54

Thank's for your help.

[eKuliscool]

Hello guys I really need your support because i tried to modify my bios and flashed it and after that nothing worked anymore...
My Thinkpad T480 doesnt turn on anymore and there are no lights, fan spinning etc... - so basically dead. The only thing working is when i plug it via AC then it charges.
I flashed the bios Chip with a lot of other verions provided in this post and nothing helped unfortunalty.
My Setup is the following:
Lenovo Thinkpad T480
Type: 20L6-S29E0C
S/N: PP-1QC3TB
Mainboard: i can"t tell you the exact Mainboard because i couldnt find any information about it on itself but i guess its ET480 NM-B501 as usual because i havent seen any other serial number for it.
I would really appreciate the help because i really despair at this task.
So if someone could help me and also need some more information i would love to provide them.
(If its possible to give me an bios with a patched version (advanced menu, overclocking and erasing wwan whitelist) it would be even more perfect but not needed )
I have no back up bios - because mine was broke and the only thing that matter is that my T480 will work again.
Best regards and Thanks

[anirash25]

Please help Clear the Bios Password Lenovo T480
MB Part No: NM-B501
Laptop Serial No : PF-1K59S7

[SMDFlea]

Try the Autopatcher - https://www.badcaps.net/forum/troubl...emoval?t=87588

[ali0robot]

Please help Clear the Bios Password Lenovo T480
MB Part No: NM-B501
Laptop Serial No : PF-1K59S7

try

[ali0robot]

Hello guys I really need your support because i tried to modify my bios and flashed it and after that nothing worked anymore...
My Thinkpad T480 doesnt turn on anymore and there are no lights, fan spinning etc... - so basically dead. The only thing working is when i plug it via AC then it charges.
I flashed the bios Chip with a lot of other verions provided in this post and nothing helped unfortunalty.
My Setup is the following:
Lenovo Thinkpad T480
Type: 20L6-S29E0C
S/N: PP-1QC3TB
Mainboard: i can"t tell you the exact Mainboard because i couldnt find any information about it on itself but i guess its ET480 NM-B501 as usual because i havent seen any other serial number for it.
I would really appreciate the help because i really despair at this task.
So if someone could help me and also need some more information i would love to provide them.
(If its possible to give me an bios with a patched version (advanced menu, overclocking and erasing wwan whitelist) it would be even more perfect but not needed )
I have no back up bios - because mine was broke and the only thing that matter is that my T480 will work again.
Best regards and Thanks

if you have 3.3 on bios chip look for resistance around bios chip, sometime one of those resistance are misplace or lost. in most cases they are 33 or 50 ohm

[OrcunerenGungen]

Hello I have a t480 with supervisor password. I dumped the bios and patched it with the patcher on this forum. I got verification errors at first but after using another software to write with ch341a I was able to write and verify. But laptops power button blinks 3 times and nothing happens even with original bios. Can anyone take a look at my dump? I also tried other dumps from sit e but same thing. Also I noticed a resistor and 2 caps missing I bridged the resistor and left the caps as is Any Help is Much Appreciated. The resistor is r694 and it is 33 ohm and 2 missing 33p caps c576 and c577 There is 1.6v at vcc of bios and 3.3v at cs

[SMDFlea]

Hello I have a t480 with supervisor password. I dumped the bios and patched it with the patcher on this forum. I got verification errors at first but after using another software to write with ch341a I was able to write and verify. But laptops power button blinks 3 times and nothing happens even with original bios. Can anyone take a look at my dump? I also tried other dumps from sit e but same thing. Also I noticed a resistor and 2 caps missing I bridged the resistor and left the caps as is Any Help is Much Appreciated. The resistor is r694 and it is 33 ohm and 2 missing 33p caps c576 and c577 There is 1.6v at vcc of bios and 3.3v at cs

Type the laptop serial number, full name and model, motherboard model, etc.

read the forum rules..https://www.badcaps.net/forum/troubl...before-posting

[OrcunerenGungen]

SN:PF1AQ6LW Model:20L6S0AF00 cant find mobo model

[OrcunerenGungen]

I couldnt edit my post The 3.3v comes to CS after plugging adapter doesnt come with battery

[SMDFlea]

I couldnt edit my post The 3.3v comes to CS after plugging adapter doesnt come with battery

Replace the caps and resistors then it might just work properly.

[OrcunerenGungen]

I fixed the issue it was the d12 diode on the back I put a wire for now I hope it helps someone else Also you can put a wire instead of 33 ohm resistors no problem but putting a new diode is recommended

[Luis Martin]

Lenovo T480 bricked during a firmware update on ubuntu system, light on power button and fan turn on, no screen or HDMI output. Bip bip sound when turn on without RAM.

Brand: Lenovo T480
board No: Et480 nm-b501 (2018)
s/n: Pf-1EQ53J 18/09
Type: 20L5-000WUS
processor type: i5
issue: bricked during a firmware update
requesting: working BIOS.

The 3 attached files are the same DUMP with 3 different chips names for redundancy.

[SMDFlea]

Lenovo T480 bricked during a firmware update on ubuntu system, light on power button and fan turn on, no screen or HDMI output. Bip bip sound when turn on without RAM.

Brand: Lenovo T480
board No: Et480 nm-b501 (2018)
s/n: Pf-1EQ53J 18/09
Type: 20L5-000WUS
processor type: i5
issue: bricked during a firmware update
requesting: working BIOS.

The 3 attached files are the same DUMP with 3 different chips names for redundancy.

try this one.

[Luis Martin]

try this one.

Thank you SMDFlea.

Unfortunately doesn't work.

[SMDFlea]

Thank you SMDFlea.

Unfortunately doesn't work.

Did you get the update from LVFS https://fwupd.org/ ,was the EC updated as well.

[Luis Martin]

Did you get the update from LVFS https://fwupd.org/ ,was the EC updated as well.

To be honest idk, i just get a update firmware pop-up and click on it.

I find this .bin on another forum and I flash it, and it works now i got Lenovo screen and i can go to bios but .... now if i plug a hdd/ssd the system just start blinking the screen in black.
If I remove ssd the system boot from my usb to install operating system but I can't because no ssd installed. 🤔

[Luis Martin]

To be honest idk, i just get a update firmware pop-up and click on it.

I find this .bin on another forum and I flash it, and it works now i got Lenovo screen and i can go to bios but .... now if i plug a hdd/ssd the system just start blinking the screen in black.
If I remove ssd the system boot from my usb to install operating system but I can't because no ssd installed. 🤔

this bios