BA41-02047A / NIKE17-MAIN REV 1.2
anyone can help??
anyone can help??
-
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Maybe try this one? -
Re: SAMSUNG NP700Z7C - BIOS dump needed
THANKS ROBROCK1, but project name of the board is different.doubt it will workComment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
If you are lucky and its turning on, then you can use normal bios recovery process from pendrive.Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
I can also offer NP900X4C if needed.Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Thanks!Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
I know this is somewhat of an old thread but did you have any luck with finding the bios file?? I need a copy myself if you have one or anybody else.
ThanksComment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Hi upload your original i will fix it.
Techman1025Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Try this one:Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
I have a Samsung NP700Z7C-SO3PT BA41-02047A / NIKE17-MAIN Rev 1.2, original bios (off) can you repair it?
laptop, turn on with initial logo, then reboot, I think is a bad firmware update in windows.
HelpLast edited by kalu; 10-14-2015, 10:46 AM.Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Corrupted fileComment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Hi
Give it a try.
techman1025Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Hi ... again.
Today, I dicide to change the rom with a new one with a corrected file from techman1025
And computer is working ok.
The bios chip was fault, now all is OK
Thanks techman1025Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
heloo
please help i have a NP700Z7C with ba41-01941A rev: 1.0 with no image
please help with new bios
thanksComment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
heloo
please help i have a NP700Z7C with ba41-01941A rev: 1.0 with no image
please help with new bios
thanksComment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
this is the old and probbaly corupted.Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Here
techman1025Comment
-
Re: SAMSUNG NP700Z7C - BIOS dump needed
Hi,
please help i have a NP700Z7C with BA92-10916B with logo stucked,
please help with new bios.
Thanks.Comment
-
The Samsung S49CG934SU monitor does not power on - no LED indicator activity and no response to power button. However, when 21V power is connected, it immediately draws 0.8A of current with no display output. The motherboard processor gets warm, and there is continuous reading activity from the W25Q128BV BIOS chip.
Suspected Cause:
I suspect the BIOS may have been corrupted during a power interruption while updating the firmware. The official website provides firmware updates, but they can only be installed via USB flash drive.
Troubleshooting Attempts:
... -
Hi all,
My Samsung Galaxy Book 2 Pro 15.6-inch laptop has no display and won't boot.
The charging red LED lights up, but the charging screen doesn't show any indication.
When I press the power button, the blue LED cycles on and off three times, then the screen doesn't turn on, and the device won't boot.
(I've tried removing the battery and resetting the device, but the issue persists.)
NoteBook Model name : Samsung NT955XED-KK51G(Galaxy book2 pro, i5-1240p, 15.6inch AMOLED)
PCB model name : Venus2-15-5G(REV1.2), Venus2-15 ADL NPC
S/N : 5RNK9FFT70... -
Hi, I have an MSI PRO B660M-G DDR4 board with damaged BIOS and i need a bios dump from a real board, along with MAC, UUID and Serial Number info (eg. a BIOS screenshot and pictures from the board stickers).
I need to reconstruct the bios on my board, based on another bios image form a real board - meaning a bios image containing MAC address, UUID and Serial number. A stock BIOS is not suffiecient, as it is impossible to discover where the MAC, UUID and SerialNumber are stored. Tried with a similar board, but there are too much differences, and the stock BIOS is missing a lot of...11-17-2023, 10:56 AM -
Hi everyone,
I'm trying to recover a Fujitsu Lifebook E5513 (most likely 2023 model) that was bricked during a BIOS update. The update was interrupted (probably due to power loss), and now the laptop is stuck in a boot loop showing "PBB rollback" / "SBB rollback" messages.
BIOS access (F2) and Boot Menu (F12) are no longer possible – the system instantly reboots after the rollback messages.
I extracted the official BIOS update package from Fujitsu (contains FJNB2FD.CAP, ~18.7 MB) and tried tools like UEFIExtract, but it seems to only contain... -
After installing Linux, I can no longer enter the BIOS of my Samsung Series 9 (NP900X3C) laptop. When pressing [F2] during boot I simply get a black screen. Same thing when pressing [F10] and choosing "Setup" from the "App Menu" tab. Apparently this is a relatively common issue with Samsung laptops of that generation, but unfortunately i haven't been able to resolve the issue (yet).
Things i've tried so far; reinstalled Windows 10, checked for redundant boot entries, tried to factory reset using the emergency keyhole, attempted to clear the NVRAM by physically...08-01-2025, 09:15 AM
Comment