820-2850 missing ppbus_g3h

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ligym60
    Member
    • Oct 2016
    • 39
    • United States

    #1

    820-2850 missing ppbus_g3h

    Ok so I got this with quarter fan spin and it went straight to dim green light after a few minutes of diode measurements. With just the charger plugged in.
    pp3v42 = 3.42
    Ppbus_g3h = 0.3v
    Diode mode ppbus_g3h=.489

    R7020 pin1=2.4v
    C7020 resistance on 1&2 =20ohms
    Isl6295 (pins)27/28 20ohms
    Isl6295 (pins)17/18 2.9ohms
    Smc_reset_L =3.3v

    Q7085 Pins 1-4=16.24v
    Q7085 ppdcin_g3h_inrush =2.59v

    Tried with battery g3h=12.5v at fuse f7040
  • SMDFlea
    Super Moderator
    • Jan 2018
    • 20419
    • UK

    #2
    Re: 820-2850 missing ppbus_g3h

    With no power test R7021 and R7022 ohms, and check R7020 pin 1 and 2 ohms to gnd.
    All donations to badcaps are welcome, click on this link to donate. Thanks to all supporters

    Comment

    • ligym60
      Member
      • Oct 2016
      • 39
      • United States

      #3
      Re: 820-2850 missing ppbus_g3h

      R7021 pins 1 & 2 in ohms = 1.965 k ohms
      R7022 pins 1 & 2 in ohms = 1.975 k ohms
      R7022 between pins 1 & 2 =0.1

      Comment

      • ligym60
        Member
        • Oct 2016
        • 39
        • United States

        #4
        Re: 820-2850 missing ppbus_g3h

        R7022 ohms to ground I will check when I get home

        Comment

        • ligym60
          Member
          • Oct 2016
          • 39
          • United States

          #5
          Re: 820-2850 missing ppbus_g3h

          Resistance to ground on r7020 pin 1 15.39mohms pin 2 15.52m ohms

          Comment

          • Gimi
            Senior Member
            • Aug 2015
            • 75
            • UK

            #6
            Re: 820-2850 missing ppbus_g3h

            replace u7000,make sure you replace with exact same part number

            Comment

            Related Topics

            Collapse

            • ugamazing
              820-02020 PPBUS_AON missing
              by ugamazing
              Board had no history of liquid; unsure of drop history, but no signs of damage of any kind worth noting.

              Charger sitting at 5v/0a. PPBUS is at 1.9v-0.9v steady cycle (peaks, drains, loops). Confirmed CHGR_EN_MVR is missing, but DCIN was reaching ISL just fine, so replaced ISL--no change at all. Confirmed pp3v8_aon is also missing--and being unsure *exactly* which signal appears first (or if they are simultaneous), I inspected PMU/U8100 area and found no shorts, but also found PP3V8_AON_MPMU_ISNS_VIN missing (not shorted). Replaced U8100 just in case (have had them fail in weird ways),...
              02-05-2025, 04:21 PM
            • jpreza
              Apple NVIDIA AGP GeForce 6800 GT Dual Link DVI+DVI outputs 603-6338 missing caps!
              by jpreza
              Hi everyone,

              I recently acquired this card from a seller who was selling a PowerMac G5 for parts. He mentioned that the video card was probably broken too.

              Upon closer inspection, I can tell the reason why it won't work: it's missing a bunch of CAPS! (it's also missing an inductor - 1.0uH).

              It's a nice card as it's one of the few AGP cards that will support 2560 x 1600 resolution on a PowerMac G5 using a 30" Cinema Display.

              Looking at the card, it appears to be missing the following:

              1x 1.0uH inductor - orange square
              2x...
              11-01-2024, 10:54 PM
            • gurj1979
              Asus Zenbook UX431DA / UM431D - Ryzen - missing PWM Fan Signal.
              by gurj1979
              Hey guys.

              Need help with this one.
              Fan not spinning due to missing PWN Fan signal.
              Also 5 seconds from powering up it freezes, unless in BIOS.
              But as soon as Windows starts to load, it will freeze.
              CPU is COLD / Room temp when it freezes.

              I've replaced the CPU, same problem.
              Replaced SIO/KBC IT8987e and reprogrammed - same problem.
              Replaced fan - same problem.
              Replaced flex cable from board to daughterboard (which has fan connector on it) - same problem.
              Checked the Thermal sensors around CPU and Board to the SIO/KBC and...
              08-19-2024, 05:22 PM
            • salopian
              Macbook Pro Retina 13” 820-3476-A (A1502) - missing PM_SLP_S4_L
              by salopian
              Hello. I would need some advice please.

              My son's MBP suddenly stopped working and is now only getting the green-then-orange light on Magsafe and no fan spin.
              He brought the MBP into the house (22 deg C) from a very cold conservatory (-3 deg C) and turned it on straight away. The Mac suddenly died a few minutes later.

              I examined the logic board and couldn't find any signs of water damage, corrosion, blown up components etc. Nothing was ever spilt on it, and the logic board looks immaculate.

              I have already replaced the logic board with another...
              02-27-2021, 07:30 AM
            • mohamed mm
              sony vaio mbx-247, missing S5_ON signal
              by mohamed mm
              Hi everyone, I hope you are having a good day.

              I have a laptop sony Vaio, DA0HK1MB6E0, MBX-247. REV: E

              The laptop suddenly shut down as the owner told me, so I did the normal check there is no short but the laptop it's not powering up and there is no light when I connect the adapter because there is no battery.

              so I checked.
              pu9:
              Vin: 19v

              Ldo: 4.89v

              Ref:1.99v

              Vcc: 4.89v

              Vdd: 4.89v

              output

              3.3v pcu.

              EN2: 4.89v

              but No
              ...
              01-19-2023, 05:17 AM
            • Loading...
            • No more items.
            Working...