burn track in dell i 7

[hazim]

The problem I encountered at Dell Laptop core I 7
La- 9981p (vbwoo)

In picture ic 5-3 tps 51225cr is fails and pin 12 (vin) track burnt

How to soldering a wire in the track under the legs of small ic – 5 3 to work a bridge to connect electricity to this ic and install new ic

[smali]

Re: burn track in dell i 7

It is on your experience and practice I have done many times ..take a very thin wire solder it and trace the damaged line connect the wire to that component and the other side place under the ic in the burnt area and past with flux and adjust with other line of the ic equally adjust with needle and then place the ic with care and give heat.