Hi
I have just replaced the NEC/Tokin capacitor in a Toshiba A300 as per instructions on this site and Internet and YouTube etc with the 4 replacement 330's (or whichever was correct)
I am a beginner when comes to laptop repair done light stuff before and I am ok at soldering .
All seems to have gone well no problems removed easily and soldered replacements on fine .no problems that I can think of .
I just put the laptop back together and turned it on. The fan spins and sounds like turned on lights all on etc however now the screen is completely black (blank) - nothing , no flickers , no bios screen just black .
I took apart again to see if left cable disconnected or didn't seat graphics card properly but all seems fine .
Would this be caused by the capacitors ? Or is it lightly to be something else ?
Any suggestions would be appriciated .
Thanks Mark
I have just replaced the NEC/Tokin capacitor in a Toshiba A300 as per instructions on this site and Internet and YouTube etc with the 4 replacement 330's (or whichever was correct)
I am a beginner when comes to laptop repair done light stuff before and I am ok at soldering .
All seems to have gone well no problems removed easily and soldered replacements on fine .no problems that I can think of .
I just put the laptop back together and turned it on. The fan spins and sounds like turned on lights all on etc however now the screen is completely black (blank) - nothing , no flickers , no bios screen just black .
I took apart again to see if left cable disconnected or didn't seat graphics card properly but all seems fine .
Would this be caused by the capacitors ? Or is it lightly to be something else ?
Any suggestions would be appriciated .
Thanks Mark
Comment