I have a ch341a with the soic8 clip and trying to flash the bios I have plugged in the clip with the red wire to the pin with the dimple and have put the other side of the soic clip into the ch341a top sockets away from the locking pin but it doesn't detect this is driving me mad bet its something simple I'm doing wrong.
-
-
Re: ch341a doesnt detect MX25L8005
If the programmer proved and was good before & supposing you perform auto detect the chip. Then its either wrong alignment of chip, defective chip or may be defective programmer (least probable). I have bunch of these programmers and they are real hard to brick. On the other the 25x chips goes bad easier. Bad alignment though or non touching legs (often) are the culprit.Last edited by tibd; 05-13-2016, 04:51 AM. -
Re: ch341a doesnt detect MX25L8005
clip?
are you trying to program a chip while still fitted to something?Comment
-
Re: ch341a doesnt detect MX25L8005
I have managed to flash it now but it hasn't fixed the problem with the notebook it still just boots up with no display and the moon light litComment
Comment