FL Inverter cable

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • stepgr
    Member
    • Nov 2008
    • 34
    • Greece

    #1

    FL Inverter cable

    Hi,

    I have this Fujitsu Laptop (Amilo Pi 1505) and the cable for the Inverter board
    (the dc input from the laptop ) is broken. Where can one find such parts ?
    The photos are from my phone and are not clear enough but both ends have 4 pin connections with slight different connectors. I will try later to take pictures from a camera. The cable length is 35cm.
    Attached Files
  • selldoor
    Slow Learner
    • Dec 2010
    • 7870

    #2
    Re: FL Inverter cable

    http://www.ebay.co.uk/itm/Fujitsu-Am...item5d45b42539
    Please upload pictures using attachment function when ask for help on the repair
    http://www.badcaps.net/forum/showthread.php?t=39740

    Comment

    • stepgr
      Member
      • Nov 2008
      • 34
      • Greece

      #3
      Re: FL Inverter cable

      Is it working ? it might have the same problem (intermitent supply) have you checked ?

      Comment

      Related Topics

      Collapse

      • Document Archive
        Fujitsu AMILO Amilo Pi2530 - T5250 P Specification for Upgrade or Repair
        by Document Archive
        This specification for the Fujitsu AMILO Amilo Pi2530 - T5250 can be useful for upgrading or repairing a laptop that is not working. As a community we are working through our specifications to add valuable data like the Amilo Pi2530 - T5250 boardview and Amilo Pi2530 - T5250 schematic. Our users have donated over 1 million documents which are being added to the site. This page will be updated soon with additional information. Alternatively you can request additional help from our users directly on the relevant badcaps forum. Please note that we offer no warranties that any specification, datasheet,...
        09-06-2024, 05:27 AM
      • x_orange90_x
        Vizio E55-E1 bad backlights or bad inverter?
        by x_orange90_x
        I just got this tv today and it appeared to have no backlight on. After taking off the rear cover and checking again in the dark I can see that MAYBE one quadrant is lit.. But still it's quite dim. I was going to check the LEDs with my tester, and I found LED 1 and LED 2 + pins on the wire from the inverter, but I couldn't identify a ground. Nonetheless I tried using a mounting screw on the inverter board and also the chassis as ground but regardless my tester reads 300 which is what it reads when there is no voltage draw.

        I don't know how exactly to test the inverter itself. Is it...
        01-29-2025, 09:24 PM
      • Patch2
        Cable Repair
        by Patch2
        I have a broken connector (believe it's a 6 pin mini-DIN) on a cable. The metal shroud and all but one of the pins are separated from the cable, and just stuck together for the photo. The other end is an unknown rectangular connector. The cable is for the foot pedals on an Italian made electronic piano, and the company is out of business. Looking for ideas on how to fix it. I have a soldering iron, but I'm not very skilled at soldering, so getting a retrofit for the broken end may be beyond my ability. The other end would be easier to replace, if I could get a mini-DIN cable with the same number...
        01-02-2025, 06:04 PM
      • Tr0ll
        T-con suspect issue. Both ribbon cables no picture. One ribbon cable ok. (58pus8545)
        by Tr0ll
        Hi guys! I realized you have a lot of knowledge here so i am hoping you could point me in right direction with my odd issue.

        The Tv is a Philips 58PUS8545/12, it had no picture but working backlights.

        Original T-con:
        Opened the Tv and tested to unplug one ribbon cable at a time. With this test i could see that i got fine picture on both halves as long as there was only one ribbon cable connected, with two connected picture were gone.

        First replacement T-con:

        I thought it might be t-con and ordered new t-con from china(supposedly tested)...
        10-07-2023, 07:48 PM
      • Gentian
        APSINT3636VR 3600W APS INT Series 36V DC 230V AC Inverter/Charger schematic
        by Gentian
        I have a tripp-lite aspint 3636vr inverter charger which blow some of mosfet transistors. I replaced them repaired also the driver circuit and tested but the mosfets burn again.

        It work very well as inverter and also as charger if I let the rear switch in auto mode (inverter) and charger only(charging) but in auto when I connect the feed line 220V AC first time it pass ok to line and start charging the batteries but when I remove the feed line it pass to inverter mode and if I do it again the second time when passing from charging to inverter the Main transformer start making a...
        03-06-2023, 07:07 AM
      • Loading...
      • No more items.
      Working...