Announcement

Collapse
No announcement yet.

dell lcd brightness problem

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    dell lcd brightness problem

    today i change one dell latitude d430 lcd but the brightness is not same like orignal one any idea how to make it

    #2
    Re: dell lcd brightness problem

    try another

    Comment


      #3
      Re: dell lcd brightness problem

      Originally posted by alihomee View Post
      today i change one dell latitude d430 lcd but the brightness is not same like orignal one any idea how to make it
      Sometimes if your connection cable for the LCD display is not plugged in tightly enough it can cause a dim display. Recheck your connection. Also, try adjusting the display contrast to the brightest setting. Disable any ambient sensor if equipped.

      Comment


        #4
        Re: dell lcd brightness problem

        i faced the same problem. i had to replace with another dell latitude lcd. then only it fixed. i tried on changing the ccfl tube but no result.

        Comment


          #5
          Re: dell lcd brightness problem

          actually dell laptops only support the lcds which comes with inverter and specially made for dell .i think by changing the bios or fermwire chip on lcd can solve this issue.any one can point out the location of that chip

          Comment


            #6
            Re: dell lcd brightness problem

            Originally posted by alihomee View Post
            and specially made for dell
            No shit ? Shame to Dell about making your life hard.

            Comment


              #7
              Re: dell lcd brightness problem

              what about measurements ? vin, brigthness and on/off =? i think you have vin = 19v and on/off ? 3.3 but dont have brightness signal, chek with schematics and if you dont have the brightness then solder a wire from nearest 3.3v.

              Comment


                #8
                Re: dell lcd brightness problem

                disconnect the brightness pin first from the connector before solder a wire from nearest 3.3v on it . do this to avoid return current on the board .

                Comment


                  #9
                  Re: dell lcd brightness problem

                  agree to spidey . LCD screen with LVDS connector is a standard .
                  only Vin , on/off and brightness signals are necessary to light up the screen

                  Comment

                  Working...
                  X