PS5 EDM-031 Cap values

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Puuhis79
    Member
    • Nov 2020
    • 27
    • Finland
    #1

    PS5 EDM-031 Cap values

    Hi,

    working on Ps5, EDM-031. There are two caps shorted other side of southbridge,could someone check values of these from the pic (marked)

    Thanks
    1 Photo
    Tags: None
    • Puuhis79
      Member
      • Nov 2020
      • 27
      • Finland
      #2
      I soldered back those inductors, and replaced those to caps 100nF, lets see how it works

        Comment

        • Puuhis79
          Member
          • Nov 2020
          • 27
          • Finland
          #3
          Still it doesnt turn on, all voltages are present, and strange thing when 12v is connected to standby. Then it takes 280mA and hangs 10s or so something is still not working correctly... but I hooked UART and checked error codes...80810001, this could be Wifi module..lets try to replace it

            Comment

            • Puuhis79
              Member
              • Nov 2020
              • 27
              • Finland
              #4
              Wifi module removed, I took the shield of, and few caps are shorted, so this could prevent PS5 to start....

                Comment

                • SuperAman
                  Senior Member
                  • Dec 2018
                  • 119
                  • USA
                  #5
                  Originally posted by Puuhis79
                  Wifi module removed, I took the shield of, and few caps are shorted, so this could prevent PS5 to start....
                  Yes shorted wifi chip can prevent it from powering on. Does it power on without chip installed?

                    Comment

                    • stj
                      Great Sage 齊天大聖
                      • Dec 2009
                      • 30985
                      • Albion
                      #6
                      multiple bad caps?
                      what happened to this machine?

                        Comment

                        • Puuhis79
                          Member
                          • Nov 2020
                          • 27
                          • Finland
                          #7
                          Still working with this, I replaced WIFI chip, but still no permanent fix...

                            Comment

                            • RSKostya
                              New Member
                              • Oct 2021
                              • 2
                              • Russia
                              #8
                              Hello, does any one knew nominal value of this RES?
                              1 Photo

                                Comment

                                Previous template Next

                                Related Topics

                                Collapse
                                • proxneo
                                  Recapping Sony ICF-SW55 - verifying cap values
                                  by proxneo
                                  Dear reader

                                  I am performing a repair on a Sony ICF-SW55, which includes recapping (some) of the SMD capacitors on the mainboard. I am looking for verification of their values. At the moment, I'm 95% sure I've got the right values, but it is hard to find some official, credible or multiple independant sources on this.

                                  At the moment, I have selected replacements based on the following list of values:

                                  3 x 470uF 10VDC
                                  3 x 4.7uF 35VDC
                                  4 x 47uF 50VDC
                                  8 x 22uF 6.3 VDC
                                  1 x 220uF 6.3VDC
                                  5 x 100uF 6.3VDC

                                  Which...
                                  06-21-2023, 12:38 AM
                                • Kobok
                                  Different (lower) resistor values on PCB?
                                  by Kobok
                                  Dear Alls,
                                  For sure it id a stupid question, but help me to understand. I am in a Dell 2007WFP revitalizing project - searching reason why not starting. Some resistors needed to replaced is is obvious. When I have soldered some resistors the measured (with multimeter) values were sometimes rather different written on them. I supposed these are wrong units so I desoldered and made a checking measurement and voilá the values is the same is written on. This happens only in case of a few resistors, most have the same values (+/- 10%) are written on it. "strange" SMD resistors =>103...
                                  09-19-2022, 07:30 AM
                                • Maniackk
                                  Reader PocketBook InkPad 3 – identification of a black component marked 'CT' on the microUSB line
                                  by Maniackk
                                  Hello,

                                  Device: PocketBook InkPad 3
                                  Mainboard: XRZ_E091_PB740-VTTOA-V1.1 / 2017-10-12

                                  I'm replacing the broken microUSB connector on this e-reader, and during inspection after desoldering, I noticed a loose black SMD component marked "CT". One of them was torn off along with the pad, while the other one (marked in the photo) is still in place.

                                  I would appreciate help identifying this component.

                                  Measuring the loose component with a multimeter gives 5.84 MΩ in both directions, while the one still on the board shows no measurable...
                                  2 Photos
                                  05-16-2025, 08:53 AM
                                • DeXXter
                                  HP VICTUS 16-d0500la Some Values
                                  by DeXXter
                                  Here some measurements on HP Victus 16-d0500la, it might help someone, the values are on diode mode->mV and some lower ones on Resistance->Ω.

                                  This specific laptop has an Intel i5 11400h + RTX 3050TI, the values are from a working laptop....
                                  03-13-2025, 03:16 AM
                                • Francesc V.
                                  Diode marked as "E57".........not able to find it by reference
                                  by Francesc V.
                                  Hi:

                                  I have what it might seem a zener diode. It's marked as E57, but I haven't found any reference that might match my observations.

                                  I've took one from the same circuit and tested isolated with the power supply and a 1k resistor. with 10V, the possible zener stays at 6.6V.

                                  It seems a SOD123 package. It measures (2.6mm x 1.6 mm).

                                  Any idea? it's a 6.6V zener?

                                  ...
                                  06-14-2025, 09:56 AM
                                • Loading...
                                • No more items.
                                Working...