I am thinking the resistor I put in the red box is the incorrect value.
zz0.w8pmnuqvgezz...
skdsp
New Member
Last Activity: Yesterday, 05:32 PM
Joined: 09-28-2024
Location: FREMONT
-
good news lotas. i installed the following resistor values and can finally boot into the laptop but now I am constantly getting an ACPI_BIOS_ERROR blue screen loop. i wonder if I am using the wrong resistor values on the signal pin.
I am thinking the resistor I put in the red box is the incorrect value.
zz0.w8pmnuqvgezz... -
Thank you for the feedback. I will measure the resistor at the top location that you mentioned and install at the other location. At the other signal pins I measured 44 ohms. I will install that at the other 2 locations near pin 5 tonight and provide an update.Leave a comment:
-
The resistors go to pins 5 (IO0) and pin 8 (VCC).
Here is an upclose view of the PCB image i found:
...Leave a comment:
-
Need help identifying resistor values near BIOS chip on ASUS Zephyrus G14 GA402XV
Hello,
I purchased a laptop that the previous user had tried to remove and replace a BIOS chip using a soldering iron not knowing that there is a ground pad under the 25R256JWEQ chip. In that process he damaged the BIOS chip and 3 of the resistors near the IO3, CLK, and IO0 pins. I have programmed a spare 25R256JWEQ chip using a CH341A programmer but not sure what values those resistors should be. If anyone has a boardview of this area and can provide those values that would be very useful for me.
Attached is the photo.
Thank you!
No activity results to display
Leave a comment: