Nintendo Switch lite shuts down after nintendo log and replaced M96T36o
Hello everyone
After checking the defective USB-C port and close to a short circuit on the M96T36 chip (8ohm) I have changed both components.
I specify that there is no other short circuit or heating component(Vu thermal camera)
First, the problem arises: Error 2101-0001 after the start-up screen ("Nintendo" logo), poor soldering.
Secondly, I install a new M96T36 and the problem I have is a brief display of the "Nintendo" logo (no short circuit, no sure charge chip, no sure charge port, no sure charge management chip percentage).
Third; I change the USB-C port and finally the console turns on and charges correctly.
After switching off the console, the problem comes back with a brief display of the "Nintendo" logo and the console shuts down.
+ New battery.
Are you thinking of two faulty M96T36 chips (Aliexpress purchase)?
Many thanks to you
After checking the defective USB-C port and close to a short circuit on the M96T36 chip (8ohm) I have changed both components.
I specify that there is no other short circuit or heating component(Vu thermal camera)
First, the problem arises: Error 2101-0001 after the start-up screen ("Nintendo" logo), poor soldering.
Secondly, I install a new M96T36 and the problem I have is a brief display of the "Nintendo" logo (no short circuit, no sure charge chip, no sure charge port, no sure charge management chip percentage).
Third; I change the USB-C port and finally the console turns on and charges correctly.
After switching off the console, the problem comes back with a brief display of the "Nintendo" logo and the console shuts down.
+ New battery.
Are you thinking of two faulty M96T36 chips (Aliexpress purchase)?
Many thanks to you
Comment