taso
New Member
Last Activity: Yesterday, 12:15 PM
Joined: 06-16-2020
Location: seville
-
Thx! MOD1215. The EMI filter is ok, i desolder it to make sure. After making sure it was the same, I reflowed the CPU with the same result. I'll check the lines you mentioned in a bit. -
N. Switch HAc-10, no resistance on usb C 6 & 19 pin (D+), console not charging
Hi everyone:
Anybody know anything about a N.switch without resistance in 6 & 19 pin (D+) in USB C conector? This is a HAC-10 board, all conector pins al good. Console runs ok but charging in very very slow 005 mAp.
Thx!!!...
No activity results to display
Leave a comment: