T220HD flashes off after 2 seconds.

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ashmath
    New Member
    • Apr 2013
    • 1
    • england

    #1

    T220HD flashes off after 2 seconds.

    Hi turned my T220HD on this morning only to find it comes on for like 2 or 3 seconds then screen gos black the front LED stays on constantly and makes a strange noise before screen go's off. Anyhelp would be greatly appreciated?
  • JonathanAnon
    Badcaps Veteran
    • Jul 2012
    • 457
    • Ireland

    #2
    Re: T220HD flashes off after 2 seconds.

    I had one of these that the inverter transformer went on... But it could be the usual electrolytic capacitors causing your problem.. You'll need to take good quality pictures of the boards back and front, and post them here.. Then we can help you diagnose the fault..

    Comment

    • Benjaba
      New Member
      • May 2013
      • 1
      • netherlands

      #3
      Re: T220HD flashes off after 2 seconds.

      Hi
      I have the same problem, after 2 seconds the blackligt is gone.
      With a lamp over he screen and a dark room you can still see some picture.
      I checked the caps on the powerboard but they are seems to be good.
      Sorry for my bad english.

      Benjaba

      Comment

      • mariushm
        Badcaps Legend
        • May 2011
        • 3799

        #4
        Re: T220HD flashes off after 2 seconds.

        If the inverter section works fine then it could be that one of the CFL tubes is dead or going bad or one of the wires is no longer soldered properly to the cfl tube.

        Checking the ends of the cfl lamps is a bit hard, sometimes you have to remove the metal panel, and you have to gently remove the silicone jacket from the ends and sometimes just this step alone makes the wires break off from the lamp..

        Ideally you would find use a second set of tubes and replace existing connectors with your test tubes and if your test tubes light up and monitor works showing pictures then you know the lamps inside are bad (or the connection to them)

        another forum member has some nice pictures of how the lamps are inside

        http://s807.photobucket.com/user/bud...cklight%20lamp

        and here's a way to make your own test lamp from old cfl lamps:

        http://s807.photobucket.com/user/bud...ng%20old%20CFL

        Comment

        • budm
          Badcaps Legend
          • Feb 2010
          • 40746
          • USA

          #5
          Re: T220HD flashes off after 2 seconds.

          Please upload the pictures of your boards.
          Never stop learning
          Basic LCD TV and Monitor troubleshooting guides.
          http://www.badcaps.net/forum/showthr...956#post305956

          Voltage Regulator (LDO) testing:
          http://www.badcaps.net/forum/showthr...999#post300999

          Inverter testing using old CFL:
          http://www.badcaps.net/forum/showthr...er+testing+cfl

          Tear down pictures : Hit the ">" Show Albums and stories" on the left side
          http://s807.photobucket.com/user/budm/library/

          TV Factory reset codes listing:
          http://www.badcaps.net/forum/showthread.php?t=24809

          Comment

          Related Topics

          Collapse

          • JunkmanJimbo
            Samsung UN55J6200AFXZA Splash Screen Comes up, goes out, screen flashes one time and won't turn off
            by JunkmanJimbo
            Samsung UN55J6200AFXZA Splash Screen Comes up, goes out, screen flashes one time and then tv won't turn off.
            No picture. No sound that I can tell. Backlights are on and have been checked. Flashlight test no image on screen. I replaced the Eprom chip hoping that was the problem but nothing changed.
            Please help. Thanks in advance!
            Yesterday, 11:45 AM
          • Ryan.man
            Macbook 2017 with touchbar (A1706) won't turn on after removing the screen
            by Ryan.man
            Hello everybody! Posting this in hopes somebody has some expertise that leads to a clear path of troubleshooting that saves me a lot of time!

            My macbook has the flex cable problem, the one that prevents the screen turning on. Ive been dealing with this for the last 3 years. Last year it went dead and I managed to fix it following youtube tutorials. But my fix wasnt the best, the problem returned a month later. This week, it went dead again. I again tried to fix it.

            This time the original cable broke too close to the screen, it can't be fixed without tearing the screen...
            02-04-2025, 12:23 PM
          • reformatt
            Macbook Air M2 A2681 Kernel panics after screen replacement
            by reformatt
            Just had a customer bring in a M2 MBA A2681 that had had a screen replacement in April at another repairer. Since then, she has been getting intermittent kernel panics. It's an aftermarket screen, and of course it fails in diagnostics as the calibration hasn't been done. The error in the panic log is "No device added after powering on the rails".

            It seems the original repairer has swapped the board and the screen to other MAC's, and said that it isn't a screen issue. From what I understand, by doing a quick search on Google, this is in fact a screen issue. The panic relates...
            07-31-2025, 08:37 PM
          • smic717394
            iphone XS turns off when press on screen.
            by smic717394
            Hi,

            I have a iphone XS that came in for a screen replacement, the screen was badly cracked, and inside missing scues, on the back of the screen still the blue protector, the screen was a LCD. So we replaced the screen and all good, installed the screen and we noticed that pressing the screen with a bit of force but not excessive, the phone dies. After plugging the charger it turns back on, but again if you press it it dies. I open the phone again, and I can't see anything major, with the phone open, if I press on the logic board, battery, charging board, or even putting pressure on...
            07-25-2024, 10:16 AM
          • odie34
            Sony OLED XR-77A80J - 5 Flashes But Turn On After Hard Reset
            by odie34
            I am a hobbyist (not a professional) so please be gentle...

            I recently received an XR-77A80J that wouldn't turn on. (Repeating 5 flashes when plugged in.)

            I did a hard reset by holding the power button for about 30 seconds until the set powered down. I then tried to turn it on and it powered up, bringing me to the setup screen. There's not a lot of detail on the setup screen but the picture didn't have any distortions, so at least a cursory examination suggests no physical damage to the screen. The set appeared to be working normally, but it shut down after about 15 seconds,...
            02-18-2024, 09:11 AM
          • Loading...
          • No more items.
          Working...