Hello,
I am trying to repair an Hyundia LCD : X93W
When I turn on this screen, the picture is correct for two minutes, then a few blink and the picture disappear.
But with a closed light, I can see the picture
it is a problem with the backlight
I have ordered the capa kit on the lcdalternatives site, changed them but the problem is still there, I was quite sure about these capas ???
The only one, I have not changed, it is this one (100uF/450v) near the power supply, it was not in the kit
I am not an electronicien, and I don't know what to do next
I couldn't not find any information on this screen ?
I put the photos of the platine
If anybody has an idea, I will appreciate a lot
Thanks
Yves67
I am trying to repair an Hyundia LCD : X93W
When I turn on this screen, the picture is correct for two minutes, then a few blink and the picture disappear.
But with a closed light, I can see the picture
it is a problem with the backlight
I have ordered the capa kit on the lcdalternatives site, changed them but the problem is still there, I was quite sure about these capas ???
The only one, I have not changed, it is this one (100uF/450v) near the power supply, it was not in the kit
I am not an electronicien, and I don't know what to do next
I couldn't not find any information on this screen ?
I put the photos of the platine
If anybody has an idea, I will appreciate a lot
Thanks
Yves67
Comment