AG Neovo F-419 Stuck in powersave mode.

[rash.m2k]

Re: AG Neovo F-419 Stuck in powersave mode.

Not radio shack, I don't think they are any in the UK. I got them from RSonline.

They are all Nichicon, Panasonic, I didn't buy any of the cheap ones - cost me £21 inc. delivery! Bloody expensive. Anyway should be here tomorrow and I'll report back if it's fixed!

[PlainBill]

Re: AG Neovo F-419 Stuck in powersave mode.

If RS means Radio Shack forget it. They don't carry low-ESR caps. They might work... for a month or so.

Buy either from here (badcaps.net store), Digikey or Mouser.

http://www.rs-components.com/index.html

PlainBill

[Th3_uN1Qu3]

Re: AG Neovo F-419 Stuck in powersave mode.

Thanks for the tip PlainBill. Looky, they even got a distributor in Romania. I'll have to check their prices vs Farnell.

[rash.m2k]

Re: AG Neovo F-419 Stuck in powersave mode.

Thats where i ordered them from. RS. Hope these caps fix it, otherwise its £21 down the drain.

[rash.m2k]

Re: AG Neovo F-419 Stuck in powersave mode.

OK, I've replaced all the caps but it's still the same. Just sits on a yellow LED.

BTW the middle leg of U10 is chopped off and not connected is that correct?

Actually on closer inspection it looks like the yellow and the green LED are on, green is not easy to see with the yellow on. There is also a high pitch sqealing sound from it sometimes - it's not very loud but I can hear it sometimes.

[rash.m2k]

Re: AG Neovo F-419 Stuck in powersave mode.

Ok the following PDF i beleive is the correct schematic for the board.

http://www.scribd.com/doc/57048261/e...e-e71ecb8b7723

Any help would be welcome.