Don't buy those $10 PSU "specials". They fail, and they have taken whole computers with them.
My computer doubles as a space heater.
Permanently Retired Systems:
RIP Advantech UNO-3072LA (2008-2021) - Decommissioned and taken out of service permanently due to lack of software support for it. Not very likely to ever be recommissioned again.
Asus Q550LF (Old main laptop, 2014-2022) - Decommissioned and stripped due to a myriad of problems, the main battery bloating being the final nail in the coffin.
Kooky and Kool Systems
- 1996 Power Macintosh 7200/120 + PC Compatibility Card - Under Restoration
- 1993 Gateway 2000 80486DX/50 - Fully Operational/WIP
- 2004 Athlon 64 Retro Gaming System - Indefinitely Parked
- Main Workstation - Fully operational!
No. Most likely the blade is going to have only one shaft insert on one side, unless I get really lucky and the hole indeed goes from one side to the other, which I've rarely seen.
I do not know if this will work or not but give it a try
9 PC LCD Monitor
6 LCD Flat Screen TV
30 Desk Top Switching Power Supply
10 Battery Charger Switching Power Supply for Power Tool
6 18v Lithium Battery Power Boards for Tool Battery Packs
1 XBox 360 Switching Power Supply and M Board
25 Servo Drives 220/460 3 Phase
6 De-soldering Station Switching Power Supply 1 Power Supply
1 Dell Mother Board
15 Computer Power Supply
1 HP Printer Supply & Control Board * lighting finished it *
These two repairs where found with a ESR meter...> Temp at 50*F then at 90*F the ESR reading more than 10%
1 Over Head Crane Current Sensing Board ( VFD Failure Five Years Later )
2 Hem Saw Computer Stack Board
All of these had CAPs POOF
All of the mosfet that are taken out by bad caps
No, it's most likely similar to the one shown in post #16, hence why I think all I have to do is flip the rotor around. A shaded pole motor would be too big to fit in a fan like this.
I don't have one of my exact fan, but when I pulled out its impeller because it seemed a bit wobbly and I tried balancing it a bit better, I had a look behind it and I can confirm it looks just like the one in post #16.
I don't have one of my exact fan, but when I pulled out its impeller because it seemed a bit wobbly and I tried balancing it a bit better, I had a look behind it and I can confirm it looks just like the one in post #16.
Okay, then remove the two screws holding the bearing retainers and reassemble with the stator flipped.
The leads will exit opposite their usual place, check for mechanical interference.
It's most certainly a shaded pole motor.
When you have it apart, you'll see the heavy copper shunt bars, which is what makes them self-starting without multiple windings & a run cap or centrifugal switch.
Woodgears just shows a larger, C-frame one (that powers a gearbox).
Incidentally, those shading shunts are what limit these motors to some awful efficiency, something on the order of 30 percent.
They then exist, after the motor's at speed, as shorted turns!
"pokemon go... to hell!"
EOL it...
Originally posted by shango066
All style and no substance.
Originally posted by smashstuff30
guilty,guilty,guilty,guilty! guilty of being cheap-made!
Comment