I have a 12 volt wiper motor off a ford car that I was hoping to use to power the feed belt of a diy thickness sander but I am not sure how to hook it to a 12 volt battery. The wires on the connector are numbered with the following color
1- orange/purple
2 - white
3 -Green/Black
4 -
5 - Purple/White
6 - Black/Green
7 - Green/White
8 - Purple/White
9 - Green/Black
10 - orange/Blue
11 - purple/white
12 - Grey/brown
5,6,7and 8 are heavier gauge wire than 1,2,3,9,10,11 and 12. 4 is empty and both 5 and 8 are common
Tried a number of combinations but nothing worked Not at all sure how this should work any help greatly appreciated
1- orange/purple
2 - white
3 -Green/Black
4 -
5 - Purple/White
6 - Black/Green
7 - Green/White
8 - Purple/White
9 - Green/Black
10 - orange/Blue
11 - purple/white
12 - Grey/brown
5,6,7and 8 are heavier gauge wire than 1,2,3,9,10,11 and 12. 4 is empty and both 5 and 8 are common
Tried a number of combinations but nothing worked Not at all sure how this should work any help greatly appreciated
Comment