Which solderless fork terminal is needed

[xboxhaxorz]

http://www.cdiweb.com/ProductDetail/...ZTbxoCLAfw_wcB

None of the terminals i have will fit

[stj]

Re: Which solderless fork terminal is needed

welcome to american goods - is probably the best response.

the screws are probably imperial rather than metric so you have to look a bit harder to find the right size terminals.

let me guess, if you find a fork with the right size hole, it wont fit between the plastic divider sections - right?

[dellxps15]

Re: Which solderless fork terminal is needed

i did a work with this psu and arduino. i just put some solder on the wire, and when it cold down, i put in the psu and screwed it.

[budm]

Re: Which solderless fork terminal is needed

The screw is probably 6-32 or M4, the spade terminal come in lots of different fork width.
I.E.
Skinny:
http://www.mouser.com/ProductDetail/...ft2f5KdBD7I%3d

Fat:
http://www.mouser.com/ProductDetail/...ttqsX3LJmqk%3d

[xboxhaxorz]

Re: Which solderless fork terminal is needed

The fork part was too large, i temporarily cut half of it in order to make a connection. Thanks for the link, i was originally looking on ebay and google not mouser.