Announcement

Collapse
No announcement yet.

Transformer MIP260T-T102 (RCA L26HD31) Help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Transformer MIP260T-T102 (RCA L26HD31) Help

    I have picked up this set recently and the set will operate for about 10 minutes with intermittent high pitch sounds then will shut down. I think I have isolated the problem it being a transformer MIP260T-T102 . If I cool this transformer when the whining begins the whining goes away. And if I don't the set shuts down !. where to get this transformer from is my problem now any help ?
    I will attach a picture it is the little transformer with the white label .

    Attached Files
    Cheers
    Ron



    When I told my doctor I broke my leg in two places while carrying a big Monitor, he told me to stop going to those places.

    #2
    Re: Transformer MIP260T-T102 (RCA L26HD31) Help

    I would like to point out that when cooling T102 you are cooling a lot of other things in that area... In particular U102 and CON1 and Q101 and D101.

    Using an infrared thermometer you can pin-point the hot-spot... And a pic of the other side of the board would help.
    Last edited by el3ctroded; 07-09-2010, 04:25 PM.

    Comment


      #3
      Re: Transformer MIP260T-T102 (RCA L26HD31) Help

      point well taken . I used a small diameter rubber tube and did several test with the same result does this help ? And I also did a re solder on the obvious points
      Last edited by rb0746; 07-09-2010, 04:28 PM.
      Cheers
      Ron



      When I told my doctor I broke my leg in two places while carrying a big Monitor, he told me to stop going to those places.

      Comment


        #4
        Re: Transformer MIP260T-T102 (RCA L26HD31) Help

        getting rid of all the C(r)apXon KM would be the first thing i'd try..
        they usually dry out.. no bloating..

        Comment


          #5
          Re: Transformer MIP260T-T102 (RCA L26HD31) Help

          Well I have found the problem( bad cable connection ) seems the controller was messing signals up .
          Cheers
          Ron



          When I told my doctor I broke my leg in two places while carrying a big Monitor, he told me to stop going to those places.

          Comment


            #6
            Re: Transformer MIP260T-T102 (RCA L26HD31) Help

            Does someone in the forum know where I can obtain a schematic drawing for the MEGMEET MIP260T power supply? I have one that needs repaired. It has some blown smd's and also some electrolitics.

            Thanks in advance for any help.

            SparkeyJIm

            Comment


              #7
              Re: Transformer MIP260T-T102 (RCA L26HD31) Help

              I have located the schematic for the MIP260T power supply now all I have to do is the diagnostic work and replace capacitors C109 and C110 right off . Both are shorted. As for T102 you may want to try Thompson Consumer Electronics. They use that same supply in their L26HD31 LCD TV.

              Comment


                #8
                Re: Transformer MIP260T-T102 (RCA L26HD31) Help

                Originally posted by SparkeyJim View Post
                I have located the schematic for the MIP260T power supply now all I have to do is the diagnostic work and replace capacitors C109 and C110 right off . Both are shorted. As for T102 you may want to try Thompson Consumer Electronics. They use that same supply in their L26HD31 LCD TV.

                if u have schematic please upload
                i/p board number MIP260T
                REV A2
                2008,05.17 MADE IN CHINA

                OR NEED DATASHEET FOR IC SG3525AN
                CPBS0848G

                Comment

                Working...
                X